PRÉPAREZ-VOUS POUR L'HIVER : de 10 % à 50 % de réduction sur toutes les pièces d'origine !

Sauf interdiction par le fabricant. N'inclut pas les produits de rechange ou de marque Crowley Marine. Prix indiqué.

Nos entrepôts sont fermés le jeudi 26 et le vendredi 27 novembre. Joyeuse fête de Thanksgiving des États-Unis!

Recherche Plus d'un 1 million de pièces d'équipementier
Facile à utiliser  schémas des pièces Meilleur prix  garanti Assistance en directexperte   Plus de 50 ans  au service des plaisanciers Grand choix de pièces OEM  -  de 1950 à 2026 La plupart des pièces en stock  -  Exécution le jour même
Pièces en stock- Exécution le même jour

Bracket Unit [Steering Handle] [2008]

Produits associés:

Applicable Models

Model group Year Model Serial
Yamaha International 2001 - 2005 4hp All
Yamaha Outboard 1999 - 2005 4hp All

Bracket Unit [Steering Handle] [2008]
LIT-18616-01-79
Yamaha Marine

EXPLODED DIAGRAM

REMOVAL AND INSTALLATION CHART

Step Procedure/Part name Q'ty Service points
STEERING HANDLE REMOVAL Follow the left "Step" for removal
Carrying handle 2 (protector)
Bottom cowling 2
Carrying handle 1
Engine stop switch lead NOTE: Disconnect from the power unit side.
Choke wire
Throttle cable
Bottom cowling 1
1 Bolt (steering bracket) 2
2 Steering bracket 1
3 Dowel pin 1

EXPLODED DIAGRAM

Step Procedure/Part name Q'ty Service points
4 Bolt (steering handle ass'y) 1
5 Steering handle cover 1
6 Collar 1
7 Plate washer 1
8 Steering handle ass'y 1
9 Collar 1
10 Rubber bushing 1
Reverse the removal steps for installation.

SERVICE POINTS

Rubber bushing installation

  1. Install:
    • Rubber bushing

• Align the projection (a) on the pressure fit side of the rubber bushing flange with the projection (b) on the steering bracket.
• Push the rubber bushing on its inner cylinder in the direction of the arrow as shown and pressure fit it into the steering bracket.
• After fitting it, check that there is no clearance between the bushing flange and the steering bracket end (c).

Throttle cable installation

  1. Install:
    • Throttle cable

The throttle cable should be routed through the cut (a) in the steering handle cover with the outer tube end (b) in contact with the step (c) in the steering handle.

EXPLODED DIAGRAM

REMOVAL AND INSTALLATION CHART

Step Procedure/Part name Q'ty Service points
STEERING HANDLE DISASSEMBLY Follow the left "Step" for disassembly.
Steering handle ass'y
(1) Metal washer 2
(2) Wave washer 1
(3) Collar 1
(4) Cotter pin 1
(5) Friction adjusting screw 1
(6) Screw 1
(7) Steering grip 1
(8) Washer 1

EXPLODED DIAGRAM

Step Procedure/Part name Q'ty Service points
(9) Spring 1
(10) Bushing 1
(11) Bolt 2
(12) Plate 1
(13) Throttle shaft 1
(14) Friction piece 1
(15) Throttle cable 1
(16) Steering handle 1
Reverse the disassembly steps for assembly.
Share on social:

Produits associés