PRÉPAREZ-VOUS POUR L'HIVER : de 10 % à 50 % de réduction sur toutes les pièces d'origine !

Sauf interdiction par le fabricant. N'inclut pas les produits de rechange ou de marque Crowley Marine. Prix indiqué.

Nos entrepôts sont fermés le jeudi 26 et le vendredi 27 novembre. Joyeuse fête de Thanksgiving des États-Unis!

Recherche Plus d'un 1 million de pièces d'équipementier
Facile à utiliser  schémas des pièces Meilleur prix  garanti Assistance en directexperte   Plus de 50 ans  au service des plaisanciers Grand choix de pièces OEM  -  de 1950 à 2026 La plupart des pièces en stock  -  Exécution le jour même
Pièces en stock- Exécution le même jour

Bracket Unit [Clamp Brackets] [2004]

Produits associés:

Applicable Models

Model group Year Model Serial
Yamaha International 2004 60hp All
Yamaha Outboard 2004 60hp All

Bracket Unit [Clamp Brackets] [2004]
LIT-18616-FT-60
Yamaha Marine

Clamp brackets

Removing the clamp brackets

  1. Remove the power trim and tilt or hydro tilt. For removing procedures, see “Removing the power trim and tilt/hydro tilt” in this chapter.

  2. Loosen the self-locking nuts (1), and then remove clamp brackets (2) and (3).

  3. Remove the trim sensor (4).

Installing the clamp brackets

  1. Install the trim sensor (1) onto the port clamp brackets.

Adjust the trim sensor after installing the power trim and tilt.

  1. Assemble the clamp brackets and the swivel bracket by installing the self-locking nuts (2), then tightening them to the specified torque.

Self-locking nut 23 N•m (2.3 kgf•m, 17 ft•lb)

  1. Install the power trim and tilt or hydro tilt. For installing procedures, see “Installing the power trim and tilt” in this chapter.

  2. Inject grease into both grease nipples until grease comes out from the bushings (a).

Adjusting the trim sensor

  1. Fully tilt the outboard up, and then sup port it with the tilt stop lever (1).

After tilting up the outboard, be sure to support it with the tilt stop lever. Otherwise, the outboard could suddenly lower if the power trim and tilt unit should lose fluid pressure.

  1. Loosen the cam screws (2).

  2. Adjust the position of the trim sensor (3), and then tighten the screws (2) finger tight.

  1. Fully tilt the outboard down.

  2. Measure the trim sensor resistance. Repeat steps 1-5 if out of specification.

Trim sensor setting resistance: Pink (P) - Black (B) 9-11 Ω at 20 °C (68 °F)

  1. Fully tilt the outboard up, and then sup port it with the tilt stop lever.

After tilting up the outboard, be sure to support it with the tilt stop lever. Otherwise, the outboard could suddenly lower if the power trim and tilt unit should lose fluid pressure.

  1. Tighten the cam screws (2) to the specified torque.

Trim sensor cam screw (2): 2 N•m (0.2 kgf•m, 1.4 ft•lb)

  1. Fully tilt the outboard down.
Share on social:

Produits associés