¡PREPÁRATE PARA EL INVIERNO: Descuentos del 10 al 50 % en todas las piezas OEM!

A menos que lo prohíba el fabricante. No incluye productos de recambio ni productos de la marca Crowley Marine. Precio indicado.

Nuestros almacenes están cerrados el jueves 26 y el viernes 27 de noviembre. ¡Feliz Día de Thanksgiving de los Estados Unidos!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

OIL PUMP AND MANIFOLD KITS, P/N 5007476, 5007477 INSTALLATION INSTRUCTIONS

Duración de la reparación: 1 to 2 hours
Dificultad de la reparación: Easy
OIL PUMP AND MANIFOLD KITS, P/N 5007476, 5007477 INSTALLATION INSTRUCTIONS
BRP Marine

APPLICATION

Use this instruction sheet when installing a replacement oil pump and manifold on 2007 and prior Evinrude® E-TEC® outboards, 40–90 HP. DO NOT install on any other models

Ref. P/N Name of Part Qty
1 5007476 PUMP & MANIFOLD Assy, 40-60 HP 1
1 5007477 PUMP & MANIFOLD Assy, 75-90 HP 1
2 351416 *SEAL 1
3 351159 CLAMP (60.5 mm) 2
4 - *SOFTWARE UPDATE CD 1

INSTALLATION

When installing this oil pump on 2007 and prior models, EMM programming MUST be updated with the enclosed Service Update software to enable the LOW OIL and NO OIL warnings.

To begin the update process, use diagnostic interface cable, P/N 0437955, to connect a laptop computer to the engine diagnostic connector. Turn the key switch ON.

DO NOT run the Evinrude Diagnostic software program while performing this update.

Insert the update disc into the computer. The first update screen should appear. If the update does not start automatically, navigate to the CD in the computer’s file system and double-click the “InlineOilUpdate” icon.

Click the “NEXT” button.

When the second screen appears, click the “CONNECT” button.

The program will communicate with the EMM to check the model number, serial number, and software version.

If the update was previously installed, or is not intended for this engine, the following message will appear: Engine not qualified for update.

If the engine is qualified, click the “NEXT” button to continue.

Follow, in order, the five steps on the screen:

  • Turn the key switch OFF.

  • Install the Bootstrap tool into the key switch harness.

  • Turn the key switch ON.

  • Click the “CONFIRM BOOTSTRAP” button.

  • Click the “UPLOAD” button.

A progress bar will confirm the software upload.

When the upload is complete:

  • Click the “OK” button.

  • Turn the key switch OFF.

  • Remove the Bootstrap tool.

5007476 - KIT AY,OIL PUMP-I2
5007477

Share on social: