Self-diagnosis
Diagnosing the electronic control system
- Connect the special tools to the outboard motor as shown.

When performing this diagnosis, all of the electrical wires must be properly connected.
Diagnostic test lead: YB-06795
Start the engine and let it idle.
Check the flash pattern of the diagnostic indicator to determine if there are any malfunctions.
Normal condition
(no defective part or irregular processing is found)Single flash is given every 4.95 seconds.
(a): Light on, 0.33 second
(b): Light off, 4.95 seconds

- Trouble code indication
Example: The illustration indicates code number 23.
(a): Light on, 0.33 second
(b): Light off, 4.95 seconds
(c): Light off, 0.33 second
(d): Light off, 1.65 seconds

- If a flash pattern listed in the diagnosis code chart is displayed, check the malfunctioning part according to the flash pattern.
When more than one problem is detected, the light of the diagnostic tester flashes in the pattern of the lowest numbered problem. After that problem is corrected, the light flashes in the pattern of the next lowest numbered problem. This continues until all of the problems are detected and corrected.
| Code | Symptom |
|---|---|
| 1 | Normal |
| 13 | Incorrect pulser coil signal |
| 15 | Incorrect engine temperature sensor signal |
| 18 | Incorrect throttle position sensor signal |
| 19 | Incorrect battery voltage |
| 23 | Incorrect intake air temperature sensor signal |
| 28 | Incorrect neutral switch signal |
| 29 | Incorrect intake air pressure sensor signal |
| 37 | Incorrect idle speed control signal |
| 39 | Incorrect oil pressure sensor signal |
| 44 | Incorrect engine stop lanyard switch signal |
| 45 | Incorrect shift cut switch signal |
| 46 | Incorrect thermoswitch signal |
