¡PREPÁRATE PARA EL INVIERNO: Descuentos del 10 al 50 % en todas las piezas OEM!

A menos que lo prohíba el fabricante. No incluye productos de recambio ni productos de la marca Crowley Marine. Precio indicado.

Nuestros almacenes están cerrados el jueves 26 y el viernes 27 de noviembre. ¡Feliz Día de Thanksgiving de los Estados Unidos!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

Service Manual DF70, DF60 Self-Diagnostic System [26][Df70, Df60]

Productos relacionados:
Service Manual DF70, DF60 Self-Diagnostic System [26][Df70, Df60]
99500-99E13-01E
Suzuki Marine

SELF-DIAGNOSTIC SYSTEM

The self-diagnostic system alerts the operator when an abnormality occurs in a signal from the sensor, switch, etc. When the system is activated, the “CHECK ENGINE” lamp flashes (lights intermittently) according to each code pattern along with a buzzer sound.

When the engine is running, the buzzer sounds a series of short (0.2 sec.) beeps. When the engine is not running, the buzzer sounds according to each code pattern, but not simultaneous with the lamp flash. The buzzer sound, activated by the self-diagnostic system, can be temporally canceled by pushing the ignition key in. (Remote control model only)

On the tiller handle model, alerts is signaled by a sound sequence only from the buzzer contained in the tiller handle.

PRIORITY/CODE/PATTERN FOR SELF-DIAGNOSTIC SYSTEM OPERATION

• If more than two items fail at once, the self-diagnostic indication appears according to priority order. The indication repeats three times.
• If the failed item remains, the self-diagnostic indication appears again after turning the ignition switch “ON”.
• After correcting failed item, the self-diagnostic indication appears until the ECM receives the proper signal with the engine running.
• For the cylinder temp. sensor, the exhaust manifold temp. sensor or the IAT sensor, the self-diagnostic indication will be canceled after corrective action by turning the ignition switch “ON”. (The ECM will require 10 – 20 seconds after turning the ignition switch “ON” to cancel the self-diagnostic indication.)

The self-diagnostic indication may be canceled by turning ignition switch “ON” because the ECM detects only battery voltage, not charging output. Under this condition the buzzer will not sound a 1-1 code. However, if the rectifier & regulator have failed, the self-diagnostic indication will again appear after starting the engine.

CONDITION FOR SELF-DIAGNOSTIC SYSTEM OPERATION

This condition will be caused by IAC valve failure or incorrect by-pass air screw adjustment. If IAC valve is always closed or by-pass air is too low, the ECM controls the IAC valve duty to increase to maintain the idling/trolling speed specified.

This condition will be caused by disconnected, kinked or clogged MAP sensor hose or clogged inlet maniford.

Share on social:

Productos relacionados