¡PREPÁRATE PARA EL INVIERNO: Descuentos del 10 al 50 % en todas las piezas OEM!

A menos que lo prohíba el fabricante. No incluye productos de recambio ni productos de la marca Crowley Marine. Precio indicado.

Nuestros almacenes están cerrados el jueves 26 y el viernes 27 de noviembre. ¡Feliz Día de Thanksgiving de los Estados Unidos!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

Service Manual DF70, DF60 Pinion Gear Back-Up Shim [88][Df70, Df60]

Productos relacionados:
Service Manual DF70, DF60 Pinion Gear Back-Up Shim [88][Df70, Df60]
99500-99E13-01E
Suzuki Marine

PINION BEARING

Removal/installation is in the following procedure.

Removal & Installation Tools

        09951-59910: Shaft (removal & installation) (1)
        09551-39914: Plate (2)
        01500-08403: Bolt (3)
        09951-19421: Attachment (4)
        09917-98221: Spacer (Attachment) (5)
        09930-30104: Sliding hammer (6)

REMOVAL

  1. Place the attachment 4 inside the pinion bearing.

  2. Insert the shaft (1) into the attachment (4).

  3. Thread the sliding hammer (6) into the top of the shaft (1).

  4. Put a wood block under the pinion bearing.

  5. Drive the pinion bearing out downward by striking the top of the shaft (1) with the sliding hammer (6).

● When removing the pinion bearing, use care to avoid damaging the gearcase.
● Do not re-use the pinion bearing once removed.
Always use a new pinion bearing.

INSTALLATION

● Before installing the bearing, ensure that the inside of the gearcase is clean and free of debris.
● Ensure that the bearing stamped mark faces upward.

  1. Set the shaft (1), the plate (2), the spacer (5), the attachment (4) and the pinion bearing as shown in the figure.

  2. Place the shaft 1 (with the pinion bearing on the end of the shaft) into the gearcase.

  3. Secure the plate (2) by tightening the bolts (3).

  4. Thread the sliding hammer (6) into the top of the shaft (1).

  5. Drive the pinion bearing down into position by gently striking the shaft 1 until the dimension between the undersurface of the shaft (1) shoulder and the top surface of the plate (2) become 3 mm.

Share on social:

Productos relacionados