OPERATING HOUR INDICATION SYSTEM
(For remote control model)
When the ignition switch is initially turned “ON” (from “OFF”), the ECM tests the caution system by turning on all four lamps in the monitor-tachometer and sounding the caution buzzer for an initial two seconds.
For the next three seconds, the ECM indicates the total operating hours, using a combination of the tachometer needle and “REV-LIMIT” lamp flashing.
The total operating hours displayed are those of actual engine operation, not ignition switch “ON” time.

CHART OF TOTAL OPERATING HOURS INDICATION

*: One flashing is corresponded to 500 hours.
