FAIL-SAFE SYSTEM
The fail-safe system is closely related to the self-diagnostic system.
When an abnormality occurs in a sensor signal, the ECM ignores the out-of-range signal and assumes a pre-programmed value for the failed sensors.
This allows the engine to continue running under the fail-safe condition.
PRE-PROGRAMMED VALUE FOR FAIL-SAFE SYSTEM
| FAILED ITEM | PRE-PROGRAMMED VALUE |
|---|---|
| MAP sensor 1 | • 319 – 475 mmHg (Correspond to approx. 750 – 4 000 r/min) [NOTE1] |
| CKP sensor | Based on signals from CMP sensor: •Ignition timing fixed at BTDC 5° • Normal sequential fuel injection |
| CMP sensor | Based on signals from CKP sensor: (a) Failed while engine running • Ignition timing fixed at BTDC 5° • Normal sequential fuel injection (b) Failed prior to engine start • Ignition timing fixed at BTDC 5° • 1 simultaneous injection for all cylinder per 2 crankshaft rotations. |
| Cylinder temp. sensor | 60 °C (140 °F) |
| IAT sensor | 45 °C (113 °F) |
| Exhaust manifold temp. sensor | 60 °C (140 °F) |
There is no back-up system for the ECM itself. The engine will stop if it has failed.
This value will change according to the current engine speed.
