REMOVAL / INSTALLATION

(1) Bolt (1)
(2) Washer (1)
(3) Key (1)
(4) Flywheel (1)
(5) Battery charge coil (1)
(6) Screw (3)
(7) Rectifier & regulator (1)
(8) Bolt (2)
(9) Fuse case (1)
(10) 30A fuse (1)
REMOVAL

Prior to removing electrical parts:
● Disconnect battery cables from battery.
Battery charge coil
● Remove flywheel. (See page 3-48.)
● Remove three screws securing the battery charge coil.
● Disconnect battery charge coil lead wire connector from rectifier & regulator.
Rectifier & regulator
● Remove two bolts securing the Rectifier & regulator.
● Disconnect lead wire connectors.

Fuse case
● Disconnect fuse case lead wires from engine wiring harness and starter motor relay terminal.

INSTALLATION
Installation is reverse order of removal with special attention to the following step.
Battery charge coil
● Apply Thread Lock 1342 to the coil securing screws.
99000-32050 : Thread Lock 1342
Wire routing
● Check wire routing. (See page 10-1 to 10-4)
