¡PREPÁRATE PARA EL INVIERNO: Descuentos del 10 al 50 % en todas las piezas OEM!

A menos que lo prohíba el fabricante. No incluye productos de recambio ni productos de la marca Crowley Marine. Precio indicado.

Nuestros almacenes están cerrados el jueves 26 y el viernes 27 de noviembre. ¡Feliz Día de Thanksgiving de los Estados Unidos!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

Service Manual DF40, DF50 Reassembly [162][Df40, Df50]

Productos relacionados:
Service Manual DF40, DF50 Reassembly [162][Df40, Df50]
99500-87J08-01E
Suzuki Marine

REASSEMBLY

Reassembly is reverse order of removal with special attention to the following steps.

CLAMP BRACKET

Insert PORT and STBD bushings (2) into the swivel bracket (1). Install clamp bracket (3), (4) and clamp bracket shaft 5 to swivel bracket (1).

Install clamp bracket shaft nut (6). Leave nut loose for easier installation of PTT unit.

Before installing clamp bracket to swivel bracket, apply grease to clamp bracket shaft and bushings.

Install PTT unit assembly, lower shaft and bushings in position between clamp brackets.

(See “INSTALLATION” in POWER TRIM & TILT section for PTT unit installation.)

Tighten clamp bracket shaft nut (6) to specified torque.

STEERING BRACKET

Apply Water Resistant Grease to steering bracket shaft.

Apply grease to bushings, oil seal lip and pilot shaft portion of steering bracket.

Install upper bushing (1), steering adjuster (2) and washer (3) to swivel bracket.

Be certain that steering adjuster (2) is placed between upper bushing (1) and swivel bracket casing.

Install lower bushing (4) and swivel bracket seal (5) to swivel bracket.

Install seal (5) with lip (spring side) facing downward.

Install steering bracket (6) to swivel bracket.

LOWER MOUNT BRACKET

Install washer (7) and shim (8), and then slide the lower mount bracket (9) upward on the splines until it contacts the shim. Install circlip (10) to retain bracket.

BONDING WIRE

Reattach bonding wire to clamp bracket and swivel bracket, then ntighten screw securely.

The insulation washer must be installed between the bonding wire terminal and bracket.

LUBRICATION

The insulation washer must be installed between the bonding wire terminal and bracket.

Share on social:

Productos relacionados