PRÉPAREZ-VOUS POUR L'HIVER : de 10 % à 50 % de réduction sur toutes les pièces d'origine !

Sauf interdiction par le fabricant. N'inclut pas les produits de rechange ou de marque Crowley Marine. Prix indiqué.

Nos entrepôts sont fermés le jeudi 26 et le vendredi 27 novembre. Joyeuse fête de Thanksgiving des États-Unis!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

Service Manual DF40, DF50 Oil Pressure [39][Df40, Df50]

Productos relacionados:
Service Manual DF40, DF50 Oil Pressure [39][Df40, Df50]
99500-87J08-01E
Suzuki Marine

OIL PRESSURE

Oil pressure ( at normal operating temp. ): 300 - 380 kPa (3.0 - 3.8 kg/cm2, 43 - 54 psi.) at 4000 r / min.

The figure shown above is a guideline only, not an absolute service limit.
If oil pressure is lower or higher than specification, the following causes may be considered.
(See page 6-66 for oil passage locations)

Low oil pressure
• Clogged oil filter
• Leakage from oil passages
• Defective oil pump
• Defective oil pressure regulator
• Damage O-ring
• Combination of above items.

High oil pressure
• Using an engine oil of too high viscosity
• Clogged oil passage
• Clogged oil pressure regulator
• Combination of above items

TEST PROCEDURE

(1) Check the engine oil level.
(2) Remove the PORT side lower cover.
(3) Remove the plug (1) for oil pressure service port.

(4) Install the oil pressure gauge in place of service port.

09915-77310 : Oil pressure gauge
09915-78211 : Oil pressure gauge adapter

(5) Remove bolt and No.1 ignition coil.
(6) Connect special tool (H . T cord with plug cap adapter) between No.1 ignition coil and spark plug.

09930-88720 : H . T cord with plug cap adapter

(7) Attach engine tachometer to the special tool.

09900-26006 : Engine tachometer

(8) Start the engine and warm up engine as follow :

Summer : 5 min. at 2000 r / min.
Winter : 10 min. at 2000 r / min.

(9) After warming up, shift into forward gear and increase the engine speed to 4000 r / min. then compare the pressure indicated on the gauge to specifications.

(10) After testing, reinstall parts removed earlier. (plug, side lower cover, etc.)

Share on social:

Productos relacionados