¡PREPÁRATE PARA EL INVIERNO: Descuentos del 10 al 50 % en todas las piezas OEM!

A menos que lo prohíba el fabricante. No incluye productos de recambio ni productos de la marca Crowley Marine. Precio indicado.

Nuestros almacenes están cerrados el jueves 26 y el viernes 27 de noviembre. ¡Feliz Día de Thanksgiving de los Estados Unidos!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

Service Manual DF40, DF50 Oil Change Reminder System [236][Df40, Df50]

Productos relacionados:
Service Manual DF40, DF50 Oil Change Reminder System [236][Df40, Df50]
99500-87J08-01E
Suzuki Marine

Step 1: OIL CHANGE REMINDER SYSTEM

This system informs the operator of the time for replacing ENGINE OIL on the basis of the recommended maintenance schedule.

When the total motor operating hours have reached the preprogrammed hours;

  • On the tiller handle model, the buzzer will begin a series of double beeps for approx. 1 minute.
  • On the remote control model, the “OIL” lamp will flash, and the buzzer will begin a series of double beeps if engine is not running (but ignition switch is ON).

The above mentioned indication will repeat until canceling system activation.

Step 2: INDICATION OF SYSTEM ACTIVATION

Tiller Handle Model

Remote Control Model

On the tiller handle model, the buzzer for system activation will first begin to sound when the engine is stopped (but ignition switch is ON) after reaching the preprogrammed hours.

Buzzer         OIL lamp

Step 3: FLOWCHART OF SYSTEM ACTIVATION AND CANCELLATION

*1 : Lapse of initial 20 hour’s operation
*2 : Lapse of 80 hour’s operation
*3 : Lapse of 100 hour’s operation
*4 : When performing cancellation before system activation

This system will activate up to 2100 hour’s operation.

Step 4: CANCELLATION

Procedure

  1. Turn the ignition key to the “ON” position.
  2. Pull out the emergency stop switch plate (1).
  3. Pull up the emergency stop switch knob (2) three times in seven seconds. A short beep will be heard if the cancellation is successfully finished.
  4. Turn the ignition key to the “OFF” position.
  5. Set the plate (1) in the original position.

• Canceling of the system activation is possible regardless of whether or not the engine oil has been replaced. Once the system has operated, however, Suzuki strongly recommends that the engine oil be replaced before canceling the system activation.
• Even if the engine oil has been replaced with the system not operating, it is still necessary to perform the cancellation.

Share on social:

Productos relacionados