¡PREPÁRATE PARA EL INVIERNO: Descuentos del 10 al 50 % en todas las piezas OEM!

A menos que lo prohíba el fabricante. No incluye productos de recambio ni productos de la marca Crowley Marine. Precio indicado.

Nuestros almacenes están cerrados el jueves 26 y el viernes 27 de noviembre. ¡Feliz Día de Thanksgiving de los Estados Unidos!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

Service Manual DF40, DF50 Inspection For Resistance [75][Df40, Df50]

Productos relacionados:
Service Manual DF40, DF50 Inspection For Resistance [75][Df40, Df50]
99500-87J08-01E
Suzuki Marine

INSPECTION FOR RESISTANCE

09930-99320 : Digital tester
Tester range : Ω (Resistance)

Make sure ignition switch is always OFF when measuring resistance.

(1) Disconnect battery cables from battery.
(2) Disconnect all wires from ECM.
(3) Connect the tester probes to terminal of wire harness side, and measure resistance according to the “RESISTANCE TABLE".

RESISTANCE TABLE

1: Disconnect remote control wire harness, and connect tester probe to terminal (A) (Gray wire).

OTHER INSPECTION

FUEL INJECTOR OPERATING SOUND (CRANKING)
(1) Touch a sound scope or long blade screw driver to fuel injector body as shown.
(2) Crank engine and check for injector operating sound.

Injector operating sound : “Click”

FUEL INJECTOR OPERATING SOUND (INDIVIDUAL)
(1) Disconnect fuel injector wire, and connect the test cord.

09930-89260 : Injector test cord A

(2) Connect Gray wire to body ground.
(3) Momentarily touch Black/Yellow wire to starter motor relay right terminal (connected to battery positive (+) terminal), and check for injector operating sound.

Injector operating sound : “Click”

Connecting fuel injector to battery positive for more than a few seconds may cause injector overheating and possible injector solenoid failure.

FUEL INJECTOR OPERATING SIGNAL

09930-89930 : 8-pin test cord

Peak voltmeter Stevens CD-77
Tester range : NEG5O

(1) Connect the test cord as shown, then turn ignition switch ON.
(2) Connect the tester probe (-) (Black) to starter motor relay right terminal (connected to battery positive (+) terminal) as shown.

Share on social:

Productos relacionados