¡PREPÁRATE PARA EL INVIERNO: Descuentos del 10 al 50 % en todas las piezas OEM!

A menos que lo prohíba el fabricante. No incluye productos de recambio ni productos de la marca Crowley Marine. Precio indicado.

Nuestros almacenes están cerrados el jueves 26 y el viernes 27 de noviembre. ¡Feliz Día de Thanksgiving de los Estados Unidos!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

Service Manual DF40, DF50 Inspection [89][Df40, Df50]

Productos relacionados:
Service Manual DF40, DF50 Inspection [89][Df40, Df50]
99500-87J08-01E
Suzuki Marine

Step 1: INSPECTION

IGNITION SWITCH

09930-99320 : Digital tester
Tester range : (Continuity)

  1. Disconnect the ignition switch from remo-con box wiring harness.
  2. Check continuity between wiring leads at the key positions shown in the chart.

If out of specification, replace ignition switch.

Step 2: NEUTRAL SWITCH

Check for continuity / infinity of the neutral switch.

09930-99320 : Digital tester
Tester range : (Continuity)

Neutral switch in remo-con box

  1. Disconnect neutral switch lead wire from ignition switch and remo-con box wiring lead.
  2. Check continuity / infinity between switch brown wire leads while operating remo-con handle.
Shift position Tester indicates
Neutral Continuity
Forward Infinity
Reverse Infinity

If out of specification, replace neutral switch.

Neutral switch on cylinder block

  1. Disconnect neutral switch lead wires.
  2. Check continuity / infinity between Yellow / Green and Brown lead wires while operating remo-con handle.
Shift position Tester indicates
Neutral Continuity
Forward Infinity
Reverse Infinity

If out of specification, replace neutral switch.

After installing neutral switch, check for proper correct function by operating remo-con handle.

Step 3: STARTER MOTOR RELAY

Two methods can be used to test starter motor relay.

09930-99320 : Digital tester

Method 1

  1. Disconnect all cables / lead wires from starter motor relay.
  2. Measure resistance between relay wiring leads.

Tester range : Ω (Resistance)

Tester probe connection
Red (+) Black (-)
Yellow / Green Black

Starter motor relay solenoid coil resistance : 3.5 – 5.1 Ω

If measurement exceeds specification, replace starter motor relay.

Method 2
Connect the wiring leads of the relay to battery (12V) and check relay operation.

Tester range : (Continuity)

  1. Disconnect all cables / wires from starter motor relay.
  2. Connect Yellow /Green wire to positive (+) terminal, and Black wire to negative (-) terminal of battery.

When 12V applied : Continuity between relay terminal (1) and (2).

  1. Disconnect wiring leads from battery.

No voltage applied : No continuity between relay terminal (1) and (2).

If out of specification, replace starter motor relay.

Share on social:

Productos relacionados