Step 1: INSPECTION
If any component is worn excessively, cracked, defective or damaged in any way, it must be replaced.
Thoroughly wash all metal components with cleaning solvent and dry with compressed air.
Wear safety grasses when using compressed air.
Step 2: PROPELLER

Inspect the propeller for bent, chipped or broken blades. Replace or repair propeller if in damaged condition.
Inspect propeller bush splines. Replace or repair propeller if splines are worn or damaged.
Inspect propeller bush for deterioration or slipping. Replace if necessary.
Step 3: GEARCASE

Inspect the gearcase. Replace if cracked or damaged.
Visually check the pinion bearing. Replace if pitted, noisy or rough.
If removal and replacement are required, see the “PINION BEARING” section on page 9-5.
