¡PREPÁRATE PARA EL INVIERNO: Descuentos del 10 al 50 % en todas las piezas OEM!

A menos que lo prohíba el fabricante. No incluye productos de recambio ni productos de la marca Crowley Marine. Precio indicado.

Nuestros almacenes están cerrados el jueves 26 y el viernes 27 de noviembre. ¡Feliz Día de Thanksgiving de los Estados Unidos!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

Service Manual DF40, DF50 Idle Speed [335][Df40, Df50]

Productos relacionados:
Service Manual DF40, DF50 Idle Speed [335][Df40, Df50]
99500-87J08-01E
Suzuki Marine

ENGINE SERIAL NUMBER

The engine serial number starts from the following six-figure number located after the model prefix.

PERIODIC MAINTENANCE

IDLE SPEED

Inspect initially after 20 hours (1 month) and every 200 hours (12 months).

Change the idle speed adjustment procedure as following:

The idle adjustment of 2008 model can be performed by fixing duty of IAC valve as well as DF150 – 250 model.

• Before checking idle speed, the engine should be allowed to warm up.
• Check and/or adjust idle speed after engine speed has stabilized.

  1. Remove the bolt and No.1 ignition coil.
  2. Connect special tool between No.1 ignition coil and spark plug.

09930-88720 : H · T cord with plug cap adapter

  1. Start engine and allow to warm up.
  2. Attach engine tachometer to the ignition H. · T cord.

09900-26006 : Engine tachometer
5. Check engine speed .

Idle speed (no load): 800 – 900 r/min

ADJUSTMENT:

If the idle speed is out of specification, adjust it as follows:

  1. Shift into neutral and close the throttle fully.
  2. To set the IAC valve duty to constant 22.5 %, turn the ignition key from ON to START five times within ten seconds. At this time, the caution buzzer will sound to notify that IAC duty is in fixed mode.

• The ignition key operation should be performed with the engine running at idle.
• While IAC valve duty is at a fixed 22.5 % duty, the caution buzzer will sound in a repeating pattern of 0.5 second on with an interval of 3 seconds off.
• The fixed mode will continue for 5 minutes.

  1. During this fixed mode, adjust engine speed to 850 ± 50 r/min by turning by-pass air screw.

Turning air screw counterclockwise:
Engine speed will increase.
Turning air screw clockwise:
Engine speed will decrease.

  1. When finished adjusting the idle speed, opening the throttle will cancel the (IAC) fixed mode.

  2. Return the throttle to fully close and check engine speed. It should now be stable at 800 – 900 r/min.

Trolling speed (in- gear) is same as idle speed.

Share on social:

Productos relacionados