FUEL DELIVERY SYSTEM COMPONENTS
The fuel delivery system is composed of the low pressure line components (fuel tank, filter , pump etc.), fuel vapor separator, high pressure fuel pump, high pressure fuel filter, fuel pressure regulator (located in the fuel vapor separator), fuel injector and hoses.
Fuel is supplied through the primer bulb, low pressure fuel filter, and low pressure pump to the fuel vapor separator.
Fuel flow from the fuel vapor separator is pressurized by the high pressure fuel pump and supplied through the high pressure fuel filter and fuel delivery gallery to the fuel injectors.
The pressure regulator maintains fuel pressure in the feed line between the high pressure fuel pump and fuel injector.
This pressure , maintained at a constant level, is higher than the pressure in the vapor separator chamber. When fuel feed line pressure exceeds vapor separator chamber pressure by more than approx. 255 kPa (2.55 kg/cm², 36.3 psi.), the valve in the fuel pressure regulator will open and return the excess fuel to the vapor separator chamber.
Pressurized fuel enters into the intake ports through the fuel injector based on the sequential signals supplied from the ECM.

FUEL VAPOR SEPARATOR
The fuel vapor separator incorporates a float system that maintains a constant fuel level inside the separator chamber. As the fuel level decreases, fuel flows into the vapor separator from the low pressure fuel pump. The function of this unit is to separate vapors from fuel delivered by the low pressure fuel pump or fuel returned from the fuel pressure regulator.
This vapor is routed through the evaporation hose connecting the vapor separator cover to the air inlet cover over the flywheel.
HIGH PRESSURE FUEL PUMP
The fuel vapor separator incorporates a float system that maintains a constant fuel level inside the separator chamber. As the fuel level decreases, fuel flows into the vapor separator from the low pressure fuel pump. The function of this unit is to separate vapors from fuel delivered by the low pressure fuel pump or fuel returned from the fuel pressure regulator.
This vapor is routed through the evaporation hose connecting the vapor separator cover to the air inlet cover over the flywheel.

FUEL PRESSURE REGULATOR
The fuel pressure regulator is located in vapor separator. The regulator’ function in the system is to maintain a constant fuel pressure relative to the injector while the engine is operating.
The regulator diaphragm chamber is open to the vapor separator chamber to keep the pressure balanced. Fuel pressure, adjusted by the regulator, is constantly maintained higher than the pressure in vapor separator chamber by approx. 255 kPa (2.55 kg/cm², 36.3 psi.).
By-pass fuel is returned back to the fuel vapor separator chamber.

FUEL INJECTOR

The fuel injector is an electromagnetic valve operated by a signal from the ECM. When the injection signal is supplied to the fuel injector, the solenoid coil is energized pulling up the plunger. This opens the injector needle valve and injects fuel. Because the fuel pressure is kept constant, the amount of fuel injected is determined by the amount of time (duration) the valve is open.
