REMOVAL / INSTALLATION
FLYWHEEL / CKP SENSOR / CMP SENSOR

REMOVAL

| Prior to removing Flywheel : |
|---|
| • Disconnect battery cables from battery. |
- Remove flywheel cover.
- Loosen flywheel bolt 2 – 3 turns.
09930-48720 : Flywheel holder
Do not remove flywheel bolt at this time. This bolt prevents damage to the crankshaft when using flywheel remover tools.

- Using special tools, loosen flywheel from crankshaft.
09930-39411 : Flywheel remover
09930-39420 : Flywheel remover bolt

- Remove flywheel bolt (1), washer (2), flywheel (3) and key (4).
- Remove screws (5) and CKP sensors (6), then disconnect CKP sensor connector.

- Disconnect CMP sensor connector. Remove bolt (7) and CMP sensor (8).

INSTALLATION

Installation is reverse order of removal with special attention to the following steps.
CKP sensors
Apply Thread Lock 1342 to the sensor mounting screws.
99000-32050 : Thread Lock 1342
Flywheel

• Clean flywheel and crankshaft mating surfaces with cleaning solvent.
• Apply engine oil lightly to flywheel bolt before installing.
• Tighten flywheel bolt to specified torque.
09930-48720 : Flywheel holder
Flywheel bolt : 200 N•m (20.0 kg•m, 144.5 lb.•ft.)
