¡PREPÁRATE PARA EL INVIERNO: Descuentos del 10 al 50 % en todas las piezas OEM!

A menos que lo prohíba el fabricante. No incluye productos de recambio ni productos de la marca Crowley Marine. Precio indicado.

Nuestros almacenes están cerrados el jueves 26 y el viernes 27 de noviembre. ¡Feliz Día de Thanksgiving de los Estados Unidos!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

Service Manual DF40, DF50 Disassembly [143][Df40, Df50]

Productos relacionados:
Service Manual DF40, DF50 Disassembly [143][Df40, Df50]
99500-87J08-01E
Suzuki Marine

CYLINDER / CRANKSHAFT / PISTON

Before performing service work in this section :

  • Remove power unit (see page 6-3 to 6-6)
  • Remove timing chain (see page 6-15 to 6-16)
  • Remove cylinder head (see page 6-21)

Remove the five (5) bolts securing the upper oil seal housing to cylinder, then remove the oil seal housing.

Remove oil filter.
TOOL 09915-47341 : Oil filter wrench

Remove oil pressure switch.

Remove eight (8) bolts (1).

Remove eight (8) bolts (2).

Remove crankcase from cylinder block.

For proper assembly, mark cylinder number on all pistons, conrods, and conrod caps, using quick drying paint.

Remove all conrod cap nuts (1) and conrod caps (2).

To prevent damage to crank pin and cylinder walls, install a piece of hose over threads of rod bolts.

Remove crankshaft.

Mark cylinder number on pistons using quick dry paint.

Push piston (with conrod) out through the top of cylinder bore.

• To prevent damage to piston rings, decarbon top of cylinder bore wall before removing piston.
• Reassemble each conrod cap to its original position after removing piston from bore.

Remove two compression rings (top and 2 nd) and oil ring from piston.

Mark cylinder number on conrod using quick dry paint.

Remove piston pin circlips as shown.

Remove piston pin from conrod.

Reassemble each piston, piston pin and conrod in their original combination and position.

Share on social:

Productos relacionados