CYLINDER HEAD ASSEMBLY
REMOVAL

(Cylinder head / valve / camshaft)
Prior to removing cylinder head :
Remove the power unit. (see page 6-3 to 6-6)
Remove the timing chain. (see page 6-15 to 6-16)

- Remove the bolts securing the camshaft housing to cylinder head, then remove each camshaft housing.
For ease of assembly, note position of each individual camshaft housing.
- Remove intake and exhaust camshafts.

Loosen ten (10) cylinder head bolts in the order indicated in figure and remove them.
Remove cylinder head assembly and head gasket.
Use a special tool (10mm deep socket wrench) when loosening the cylinder head bolts.
TOOL 09919-16010 : Deep socket wrench (10 mm)
INSTALLATION
Installation is reverse order of removal with special attention to the following steps.
Do not re-use gasket. Always use a new gasket.

- Insert the dowel pins and place a new cylinder head gasket into position on the cylinder.
