¡PREPÁRATE PARA EL INVIERNO: Descuentos del 10 al 50 % en todas las piezas OEM!

A menos que lo prohíba el fabricante. No incluye productos de recambio ni productos de la marca Crowley Marine. Precio indicado.

Nuestros almacenes están cerrados el jueves 26 y el viernes 27 de noviembre. ¡Feliz Día de Thanksgiving de los Estados Unidos!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

Service Manual DF40, DF50 Cylinder Compression [40][Df40, Df50]

Productos relacionados:
Service Manual DF40, DF50 Cylinder Compression [40][Df40, Df50]
99500-87J08-01E
Suzuki Marine

CYLINDER COMPRESSION

Cylinder compression :

Standard : 1300 – 1600 kPa (13 - 16 kg / cm2, 185 – 228 psi.)
Max. difference between any two cylinders : 100kPa (1.0 kg / cm2 , 14 psi.)

Figures shown are guidelines only, not absolute service limits.

Low compression pressure can indicate one or more of the following :

  • Excessively worn cylinder wall
  • Worn piston or piston rings
  • Stuck piston rings
  • Poor seating of valves
  • Ruptured or otherwise damaged cylinder head gasket

TEST PROCEDURE

(1) Start engine and allow to warm up, then shut engine off.

(2) Remove the STBD / PORT engine side lower cover.

(3) Remove all spark plugs.

(4) Install the compression gauge into the plug hole.

TOOL 09915-64512 : Compression gauge
09915-63210 : Compression gauge adaptor

(5) Disconnect the safety lanyard (switch plate) from the emergency stop switch.

Disconnect the safety lanyard from the emergency stop switch prior to cranking the engine.
This will prevent any residual fuel discharged from the cylinders being ignited by a spark discharge from the ignition coil.

(6) Disconnect the remote control throttle cable from the throttle lever.

(7) Move and hold the throttle lever in the full-open position.

(8) While cranking the engine with the starter motor, note the maximum compression pressure reading on the gauge for each cylinder.

(9) Reinstall parts removed earlier. ( spark plug, side lower cover, etc.)

Share on social:

Productos relacionados