¡PREPÁRATE PARA EL INVIERNO: Descuentos del 10 al 50 % en todas las piezas OEM!

A menos que lo prohíba el fabricante. No incluye productos de recambio ni productos de la marca Crowley Marine. Precio indicado.

Nuestros almacenes están cerrados el jueves 26 y el viernes 27 de noviembre. ¡Feliz Día de Thanksgiving de los Estados Unidos!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

Service Manual DF40, DF50 Crankcase [358][Df40, Df50]

Productos relacionados:
Service Manual DF40, DF50 Crankcase [358][Df40, Df50]
99500-87J08-01E
Suzuki Marine

CRANKCASE BOLT

The surface treatment of the crankcase bolt has been changed. The tightening of the case bolts is performed in three stages. However, with this change effected, the torque specification for the second tightening stage has been changed. The torque specifications for the first and the final tightening remains unchanged.

Crankcase bolt tightening torque

2nd step 10 mm 37 N·m → 23 N·m

2nd step 8 mm 20 N·m → 13 N·m

CRANKCASE TO CYLINDER

  1. Clean mating surface of cylinder and crankcase.

  2. Apply sealant to mating surface of crankcase as shown.

Apply sealant to mating surface only.
Do not allow sealant to contact surface of bearing.

99000-31140: Suzuki Bond 1207B

  1. Install four (4) dowel pins (1).

  1. Install crankcase to cylinder.

  2. Apply engine oil to crankcase bolts.

  3. Tighten crankcase bolts in three (3) steps following the order indicated below.

After tightening crankcase bolts, check to be sure that crankshaft rotates smoothly when turned by hand.

Crankcase bolt

1st step 8 mm 5 N·m (0.5 kg-m, 3.5 lb.-ft.)

        10 mm 10 N·m (1.0 kg-m, 7.0 lb.-ft.)

2nd step 8 mm 13 N·m (1.3 kg-m, 9.5 lb.-ft.)

        10 mm 23 N·m (2.3 kg-m, 16.5 lb.-ft.)

Final step 8 mm 25 N·m (2.5 kg-m, 18.0 lb.-ft.)

        10 mm 46 N·m (4.6 kg-m, 33.5 lb.-ft.)

Share on social:

Productos relacionados