¡PREPÁRATE PARA EL INVIERNO: Descuentos del 10 al 50 % en todas las piezas OEM!

A menos que lo prohíba el fabricante. No incluye productos de recambio ni productos de la marca Crowley Marine. Precio indicado.

Nuestros almacenes están cerrados el jueves 26 y el viernes 27 de noviembre. ¡Feliz Día de Thanksgiving de los Estados Unidos!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

Service Manual DF40, DF50 Cleaning And Inspecting [171][Df40, Df50]

Productos relacionados:
Service Manual DF40, DF50 Cleaning And Inspecting [171][Df40, Df50]
99500-87J08-01E
Suzuki Marine

Disassembly of tilt rod / piston assembly

Unscrew the piston retaining nut from the bottom of the tilt rod and remove the washer.

Carefully retain and account for four shock valves, each com posed of a spring, rod and ball.

Remove the piston assembly and PTT cylinder head from the tilt rod by sliding them down and off the rod end.

CLEANING AND INSPECTING

Thoroughly wash all metal components with cleaning solvent and dry them with compressed air.

Arrange all components on a clean sheet of paper.

Do not lay PTT components out on a rag, as dirt or lint may be transferred to these items which may cause possible system operating problems.

Inspect tilt rod, replace if damaged or bent.

Inspect the surface of tilt rod for scores, grooves or roughness. Slight roughness may be removed with fine emery paper. A badly scored or grooved rod must be replaced.

Inspect the PTT cap seal and O-ring.

Replace if cuts, nicks, or excessive wear is found.

It is recommended that the O-ring always be replaced once the tilt cylinder has been disassembled.

Inspect the shock valves (spring, rod and ball). Replace if there are any signs of rust or pitting.

Inspect the cylinder bore for evidence of a rough or grooved surface.

Light honing may rectify slight surface roughness or scarring, but a deeply scarred surface will require replacement of the tilt cylinder.

Inspect all O-ring (manual release valve and main check valve). Replace if nicked or cut.

Share on social:

Productos relacionados