Drive Shaft Housing

| Ref. No. | Description | Q'ty | Remarks |
|---|---|---|---|
| 1 | Drive Shaft Housing “S” | 1 | Short |
| Drive Shaft Housing “L” | 1 | Long | |
| 2 | Guide Plate | 1 | |
| 3 | Screw | 2 | M5 L=10 mm |
| 4 | Exhaust Plug | 1 | |
| 5 | Dowel Pin, 6-12 | 2 | |
| 6 | Oil Seal,12-28-5 | 1 | Do not reuse. |
| 7 | Drain Bolt | 1 | M14 |
| 8 | Washer, 14.5-24-1 | 1 | |
| 9 | Grommet | 1 | |
| 10 | Idle Exhaust Port Cover | 1 | |
| 11 | Idle Exhaust Port Cover Gasket | 1 | Do not reuse. |
| 12 | Bolt | 6 | M6 L=20 mm |
| 13 | Idle Exhaust Port Grommet | 1 | |
| 14 | Apron | 1 | |
| 15 | Tapping Screw, 5-30 | 2 | M5 L=30 mm |
| 16 | Extension Housing “XL” | 1 | for Transom “XL“ |
| 17 | Bolt, 6-35 Pre-coated | 4 | for Transom “XL“ |
| 18 | Drive Shaft Bushing | 1 | |
| 19 | Bushing Stopper | 1 | |
| 20 | Bolt | 2 | M6 L=12 mm |
Lower Unit
P/L Fig. 11

| Ref. No. | Description | Q'ty | Remarks |
|---|---|---|---|
| 1 | Gear Case Ass’y | 1 | |
| 1-1 | Needle Bearing, 15-21-16 | 1 | Do not reuse. |
| 2 | Bolt, 6-35 Pre-coated | 4 | M6 L=35 mm |
| 3 | Water Strainer | 2 | W = 17 Mark “A” |
| 4 | Screw | 1 | |
| 5 | Nylon Nut, 4P-0.7 | 1 | |
| 6 | Oil Plug | 2 | |
| 7 | Water Plug | 1 | |
| 8 | Gasket, 8.1-15-1 | 3 | Do not reuse. |
| 9 | Trim Tab | 1 | |
| 10 | Bolt | 1 | M6 L=20 mm |
| 11 | Ball Bearing, 6204 | 1 | Do not reuse. |
| 12 | Propeller Shaft | 1 | |
| 13 | Clutch | 1 | |
| 14 | Spring Pin, 3.5-28 | 1 | Do not reuse. |
| 15 | Clutch Spring | 1 | |
| 16 | Clutch Push Rod | 1 | |
| 17 | Clutch Spring Retainer | 1 | |
| 18 | Bevel Gear “A” | 1 | |
| 19 | Shim, 21-28-0.1 | AR | Selection if necessary |
| Shim, 21-28-0.15 | AR | ||
| 20 | Water Seal Rubber | 1 | |
| 21 | Water Seal Plate | 1 | |
| 22 | Propeller Shaft Housing Ass’y | 1 | |
| 22-1 | Propeller Shaft Housing | 1 | |
| 22-2 | Ball Bearing, 6004 | 1 | Do not reuse. |
| 22-3 | O-Ring, 3.2-47 | 1 | Do not reuse. |
| 22-4 | Oil Seal, 15-28-10 | 1 | Do not reuse. |
| 23 | Bevel Gear “C” | 1 | |
| 24 | Washer, 15.2-19-1.9 | 1 | |
| 25 | Bolt | 2 | M6 L=20 mm |
| 26 | Propeller Thrust Holder | 1 | |
| 27 | Propeller (5), 4X221X127 | 1 | (USA : “XL”) |
| Propeller (6.5), 3X216X165 | 1 | ||
| Propeller (7), 3X226X178 | 1 | (USA : “L”) | |
| Propeller (7), 4X221X178 | 1 | (USA : “TPL”, “PL”) | |
| Propeller (7.5), 3X216X190 | 1 | “L”, “XL”, (USA : “S”) | |
| Propeller (8.5), 3X226X211 | 1 | “S” | |
| Propeller (9.5), 3X226X255 | 1 | ||
| 28 | Washer, 10.5-28-2 | 1 | |
| 29 | Propeller Nut | 1 | |
| 30 | Split Pin, 3-18 | 1 | Do not reuse. |
| 31 | Drive Shaft “S” | 1 | for Transom “S” |
| Drive Shaft “L” | 1 | for Transom “L” | |
| Drive Shaft “XL” | 1 | for Transom “XL” | |
| 31-1 | Ball Bearing, 6301 | 1 | |
| 32 | Bevel Gear “B” | 1 | |
| 33 | Water Pump Impeller | 1 | |
| 34 | Pump Impeller Key | 1 | Do not reuse. |
| 35 | Pump Case (Upper) | 1 | |
| 36 | Pump Case Liner | 1 | |
| 37 | Water Pump Guide Plate | 1 | |
| 38 | Pump Case Gasket | 1 | Do not reuse. |
| 39 | Guide Plate Gasket | 1 | Do not reuse. |

| Ref. No. | Description | Q'ty | Remarks |
|---|---|---|---|
| 40 | Bolt | 4 | M6 L=50 mm |
| 41 | Washer | 4 | |
| 42 | Pump Case (Lower) | 1 | |
| 43 | Pump Case Gasket (Lower) | 1 | Do not reuse |
| 44 | Oil Seal, 12-24-8 | 1 | Do not reuse |
| 45 | Shim, t=0.1 | AR | Selection if necessary |
| Shim, t=0.15 | AR | Selection if necessary | |
| Shim, t=0.3 | AR | Selection if necessary | |
| 46 | Water Pipe “S” | 1 | for Transom “S” |
| Water Pipe “L” | 1 | for Transom “L” | |
| Water Pipe “XL” | 1 | for Transom “XL” | |
| 47 | Water Pipe Seal (Upper) | 1 | |
| 48 | Water Pipe Seal (Lower) | 1 | |
| 49 | Water Pipe Auxiliary Mount | 1 | |
| 50 | Lock Plate | 1 | |
| 51 | Screw | 1 | M5 L=10 mm |
| 52 | Cam Rod “S” | 1 | for Transom “S” |
| Cam Rod “L” | 1 | for Transom “L” | |
| Cam Rod “XL” | 1 | for Transom “XL” | |
| 53 | Stopper | 1 | |
| 54 | Bolt | 1 | M6 L=25 mm |
| 55 | Cam Rod Bushing | 1 | |
| 56 | O-Ring, 2.5-4.9 | 1 | Do not reuse |
| 57 | O-Ring, 2.4-15.4 | 1 | Do not reuse |
| 58 | Clutch Cam | 1 | |
| 59 | Spring Pin, 3-10 | 1 | Do not reuse |
| 60 | Lower Unit Ass’y “S” | 1 | for Transom “S” |
| Lower Unit Ass’y “L” 1 | for Transom “L” |
