¡PREPÁRATE PARA EL INVIERNO: Descuentos del 10 al 50 % en todas las piezas OEM!

A menos que lo prohíba el fabricante. No incluye productos de recambio ni productos de la marca Crowley Marine. Precio indicado.

Nuestros almacenes están cerrados el jueves 26 y el viernes 27 de noviembre. ¡Feliz Día de Thanksgiving de los Estados Unidos!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

Service Manual 5008740_200-300 HP 90 ° V Oiling System [Oil System Requirements]

Productos relacionados:
Service Manual 5008740_200-300 HP 90 ° V Oiling System [Oil System Requirements]
5008740
BRP Marine

OIL SYSTEM REQUIREMENTS

Recommended Lubricants

Evinrude/Johnson XD100, XD50, or XD30 out board oils are recommended for use in Evinrude E-TEC outboards. If these oils are no t available, you must use a TC-W3 certified oil.

Evinrude/Johnson XD100 outboard oil is highly recommended for all conditions and applications.

Engine Lubricant Below 32°F (0°C)

If the outboard will be operated in temperature s below freezing (32°F, 0°C), use Evinrude/Johnson XD100.

IMPORTANT: For new outboards, test low oil warning before filling oil tank.

Turn key switch to ON. The engine monitor warning display should show “LOW OIL.”

Add enough oil to raise level to at least one-quarter capacity.

The “LOW OIL” warning should not display.

Failure to follow these recommendations could void the outboard warranty if a lubrication-related failure occurs.

COMPONENTS

The oiling system consists of the following components:

  • Oil tank
  • Oil injection pump and manifold assembly
  • Oil pressure sensor
  • Electrical circuit
  • LOW OIL and NO OIL warning systems
  • Cylinder and crankcase
  • Rear oil manifold assembly (3.3 L models)
  • Rear oil pump (3.4 L models)
  • Oil recirculation system

Oil Tank Assembly

The oil tank must be properly positioned and t he oil level must be monitored. Refer to the Predelivery and Installation Guide.

Oil Tank Components:

  • Tank, 1.8 or 3.0 gallon capacity
  • Oil pickup and filter assembly
  • LOW OIL sending unit
  • Mounting bracket and hardware
  • Protective cover (1.8 gallon tank only)
  • Primer bulb and supply hose.


1.8 Gallon Oil Tank Kit

Share on social:

Productos relacionados