EMM Transfer
EMM Transfer is used to save engine history data when the EMM must be replaced.
Select EMM Data Transfer from the Utilities menu. Select Perform Transfer From Memory and follow the instructions provided with the program.
- Select EMM Data Transfer
- Select Perform Transfer From Memory
IMPORTANT: Whenever the EMM is replaced, EMM timing must be synchronized to crankshaft position. Refer to TIMING ADJUSTMENTS on p. 112.
EMM SERVICING
IMPORTANT: If a new EMM is being installed, refer to EMM Transfer on p. 70.
Removal
Disconnect exhaust pressure hose and cooling hoses from EMM.
Disconnect J1-A, J1-B, and J2 connectors.
Remove two EMM retaining screws.
- EMM mounting screws
Lift EMM away and to the starboard side.
Installation
Align slots in starboard side of EMM case with isolator mounts o n cylinder block. Slide EMM into position.
- EMM mounting slots
- Isolator mounts
Install two EMM retaining screws. Tighten screws 12 to 16 in. lbs. (1.5 to 2 N·m).
- EMM mounting screws
Install J1-A, J1-B, and J2 connectors.
Install exhaust pressure hose and cooling hoses. Secure with tie straps.
