¡PREPÁRATE PARA EL INVIERNO: Descuentos del 10 al 50 % en todas las piezas OEM!

A menos que lo prohíba el fabricante. No incluye productos de recambio ni productos de la marca Crowley Marine. Precio indicado.

Nuestros almacenes están cerrados el jueves 26 y el viernes 27 de noviembre. ¡Feliz Día de Thanksgiving de los Estados Unidos!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

Service Manual 5008734_40-90 HP Routine Service [Pre-Season Service]

Productos relacionados:
Service Manual 5008734_40-90 HP Routine Service [Pre-Season Service]
5008734
BRP Marine

Additional Recommendations

  • Fill oil reservoir.
  • Inspect the fuel filter. If there is debris in the fuel filter, it must be replaced.
  • Replace gear case lubricant.
  • Remove and inspect propeller.
  • Clean and grease propeller shaft.
  • Blow water from gear case speedometer pickup system (gear case speedometer models only).
  • Lubricate all grease fittings and linkages.
  • Inspect outboard, steering system, an d controls. Replace all damaged and worn components. Refer to ma nufacturers and lubrication recommendations.
  • Touch up painted surfaces as needed. Coat outer painted surfaces with automotive wax.
  • Remove battery(s) from boat. S tore in a coo l, dry location. Periodically charge battery(s) while stored. Re fer to manufacturer’s maintenance recommendations when servicing batteries.
  • Store outboard in upright (vertical) position.
  • Check for fuel leakage.

Failure to check for fuel leakage could allow a leak to go undetected, resulting in fire or explosion.

PRE-SEASON SERVICE

If t he out board was remove d from the boat for storage, make sure it is reinstalled with factory specified hardware. Refer to the Pre delivery and Installation Guide.

Outboard Mounting Bolts

  • Check and re-tighten outboard mounting bolts to a torque of 40 ft. lbs. (54 N·m).

Gear case Lubricant

  • Check the lubricant level.
  • Inspect gear case for leaks. I f leak is apparent, pressure and vacuum test gear case.
  • Repair gear case as needed.

Battery(s)

  • Replace batteries that cannot be charged.

Power Trim and Tilt

  • Remove filler cap and check fluid level.
  • Inspect the power trim and tilt unit for leaks. Repair as needed.

Operational Checks
• Refer to OPERATIONAL CHECKS on p. 33

  • Steering system
  • Remote controls
  • All other accessories and instrumentation

Check Oil Injection Tank

  • Inspect the oil tank for leaks.

Check Fuel System

  • Inspect entire fuel system for leaks before starting outboard.
  • Repair all leaks.

Water Pump

  • Make sure a steady stream of water flows from overboard indicator.

Failure to check for fuel leakage could allow a leak to go undetected, resulting in fire or explosion.

Share on social:

Productos relacionados