¡PREPÁRATE PARA EL INVIERNO: Descuentos del 10 al 50 % en todas las piezas OEM!

A menos que lo prohíba el fabricante. No incluye productos de recambio ni productos de la marca Crowley Marine. Precio indicado.

Nuestros almacenes están cerrados el jueves 26 y el viernes 27 de noviembre. ¡Feliz Día de Thanksgiving de los Estados Unidos!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

Service Manual 5008734_40-90 HP Cooling System [Pressure Relief Valve Servicing]

Productos relacionados:
Service Manual 5008734_40-90 HP Cooling System [Pressure Relief Valve Servicing]
5008734
BRP Marine

COOLING SYSTEM

HEAD” facing thermostat. Refer to Cylinder Head Installation on p. 207.

002445

  1. Cylinder head seal

Inspection

Inspect all parts for cracks, heat damage, or signs of corrosion. Re place damaged p arts. Clean debris from housing and parts.

Assembly

Assembly is the reverse of disassembly. Pa y close attention when performing the following additional tasks.

Coat threads of thermostat cover with Gasket Sealing Compound and install new O-ring. Install and tighten cover to a torque of 120 to 144 in. lbs. (13.5 to 16 N•m).

PRESSURE RELIEF VALVE SERVICING

The pressure relief valve assembly should be serviced at the same time as the thermostat.

Disassembly

Remove screws and cove r from pressure valve assembly.

002443

Remove the pressure relief valve assembly.

002459

Inspection

Inspect all parts for cracks, heat damage, or signs of corrosion. Re place damaged p arts. Clean debris from housing and parts.

002442
Pressure Relief Valve Assembly Components

Assembly

Assembly is the reverse of disassembly. Pay close attention when performing the following additional tasks.

Install a new plunger seal squarely over ridge in housing.

Apply a light coat of Triple-Guard grease to a new cover o-ring and place in groove in housing.

002458

  1. Plunger seal
  2. Cover o-ring

Install valve assembly into housing.

Tighten cover screws to a torque of 60 to 84 in. lbs. (7 to 9.5 N•m).

Share on social:

Productos relacionados