¡PREPÁRATE PARA EL INVIERNO: Descuentos del 10 al 50 % en todas las piezas OEM!

A menos que lo prohíba el fabricante. No incluye productos de recambio ni productos de la marca Crowley Marine. Precio indicado.

Nuestros almacenes están cerrados el jueves 26 y el viernes 27 de noviembre. ¡Feliz Día de Thanksgiving de los Estados Unidos!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

Service Manual 5007213_Evinrude E-TEC 115-200 HP Cooling System [Pressure Relief Valve Servicing]

Productos relacionados:
Service Manual 5007213_Evinrude E-TEC 115-200 HP Cooling System [Pressure Relief Valve Servicing]
5007213
BRP Marine

THERMOSTAT SERVICING

Disassembly

Remove the thermostat cover and O-ring from each cylinder head. Remove each thermostat.

Inspection

Inspect all components for cracks, heat damage, or signs of corrosion. Replace damaged components. Clean debris from all housings and thermostat components.

Assembly

Assembly is essentially the reverse of disassembly. Pay close attention when performing the fol lowing additional tasks.

Coat threads of each cylinder head thermostat cover with Gasket Sealing Compound. Install and tighten the cover to a torque of 120 to 144 in. lbs. (13.6 to 16.3 N·m).

PRESSURE RELIEF VALVE SERVICING

Pressure relief valve assembly should be serviced at the same time as the thermostats.

Disassembly

Remove the EMM. Refer to EMM SERVICING on p. 153.

Remove the four screws holding the electrical har ness base.

  1. Harness base screws

Loosen electrical harness connections as necessary to lift harness base away from the pressure relief valve.

Remove screws and cap from pressure valve assembly.

  1. Pressure valve cap screws

Remove the pressure valve housing.

Remove the pressure valve components.

Inspection

Inspect all components for cracks, heat damage, or signs of corrosion. Replace damaged components. Clean all debris from pressure relief valve components.

Assembly

Assembly is essentially the reverse of disassembly. Pay close attention when performing the fol lowing additional tasks.

Torque cap screws to 60 to 84 in. lbs. (7 to 9.5 N·m).

Share on social:

Productos relacionados