STANDARD TORQUE SPECIFICATIONS
Standard Torque Chart
| Size | In. Lbs. | Ft. Lbs. | N·m |
|---|---|---|---|
| No. 6 | 7–10 | 0.58–0.83 | 0.8–1.1 |
| No. 8 | 15–22 | 1.25–1.83 | 1.7–2.5 |
| No. 10 | 24–36 | 2–3 | 2.7–4.0 |
| No. 12 | 36–48 | 3–4 | 4.0–5.4 |
| 1/4 in. | 60–84 | 5–7 | 6.7-9.4 |
| 5/16 in. | 120–144 | 10–12 | 13.5–16.2 |
| 3/8 in. | 216–240 | 18–20 | 24.4–27.1 |
| 7/16 in. | 336–384 | 28–32 | 37.9–43.4 |
IMPORTANT: These values apply only when a specific torque for a specific fastener is not listed in the appropriate section. When tightening two or more screws on the same part, DO NOT tighten screws completely, one at a time.
Torque wrench tightening specifications must be strictly adhered to. Replace any locking fastener (locknut or patch screw) if its locking feature becomes weak. Definite resistance to turning must be felt when reusing a locking fastener.
If replacement is specified or required because the locking fastener has become
weak, use only authorized Evinrude/ Johnson Genuine Parts.
