¡PREPÁRATE PARA EL INVIERNO: Descuentos del 10 al 50 % en todas las piezas OEM!

A menos que lo prohíba el fabricante. No incluye productos de recambio ni productos de la marca Crowley Marine. Precio indicado.

Nuestros almacenes están cerrados el jueves 26 y el viernes 27 de noviembre. ¡Feliz Día de Thanksgiving de los Estados Unidos!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

Service Manual 25-30 HP E-TEC Manual Starter [Recoil Starter Cleaning And Inspection]

Productos relacionados:
Service Manual 25-30 HP E-TEC Manual Starter [Recoil Starter Cleaning And Inspection]
5007802
BRP Marine

MANUAL STARTER

Turn housing over and tap on bench to remove spring.

Keep fingers away from uncoiling spring.
Do NOT remove spring with housing facing up. Do NOT lift spring out of housing by hand or with pliers.
Spring is under tension and will cause injury if accidentally released.

Remove two screws. Remove the rope guide.

  1. Screws

RECOIL STARTER CLEANING AND INSPECTION

Wash metal components in solvent and dry with compressed air.

Inspect the rewind spring for broken end loops and weak tension.

Examine the starter pawl for wear.

Inspect the starter components for wear. Replace as necessary.

Inspect starter rope. Replace rope if frayed. Cut new rope 80 in. (203 cm) in length. Fuse ends of rope to a length of 1/2 in. (12 mm).

Examine the pulley and the starter housing. Look for sharp edges and rough surfaces that could fray the starter rope. File and polish to remove.

Examine the starter. Replace any worn or damaged parts.

Share on social:

Productos relacionados