CONTENTS
| Item | Refer to page | |
|---|---|---|
| 1 | Electrical wiring | 3-2 ~ 3-3 |
| 2 | Fuel line | 3-4 |
| 3 | Gear oil level | 3-5 |
| 4 | . Operation of controls and moving parts | 3-5 |
| 5 | Fuel leakage | 3-5 |
| 6 | Water leakage | 3-6 |
| 7 | Exhaust leakage | 3-6 |
| 8 | Engine and lower unit noise | 3-6 |
| 9 | Idle-speed | 3-6 |
| 10 | Ignition timing | 3-6 |
| 11 | Motor exterior | 3-6 |
| 12 | Instructing the new owner | 3-6 |
ELECTRICAL WIRING
| 6CM | ✔ | 6CEM |
|---|---|---|
| 8CM | ✔ | 8CEM |
(1) C.D.I. unit
(2) Ignition coil
(3) Rectifier regulator*
(4) 2P connector*
(5)Engine stop switch
- For Europe model
B : Black
Br : Brown
G:GREEN
G/W : Greenn/White
O: Orange
R : Red
W : White
W/R :White/Red

(1) C.D.I. unit
(2) Ignition coil
(3) Neutral switch
(4)Starter switch
(5) Engine stop switch
(6) Battery
(7) Starter motor
(8)Fuse W
(9) Starter relay
(10) Rectifier
B : Black
Br : Bro
G : Green
G/W : Green/White
0 : Orange
R : Red
W : White
W/R : White/Red


FUEL LINE

PREDELIVERY SERVICE

GEAR OIL LEVEL
Remove the oil-drain
(1) and oil-level
(2) plugs, and add the gear oil through the oil drain hole until it overflows from the oil level hole. Refit the plugs. (The oil level plug first.).
OPERATION OF CONTROLS AND MOVING PARTS

Check shift control for normal operation.
Check steering control for smooth operation.
Check throttle control for smooth operation.
Check ignition timing for normal operation.
Check cowling lock and release mechanism for normal operation.
Check starting system for normal operation.
CAUTION: Use a 25:1 fuel mixture to start the engine.
WARNING: Before attempting to check the starting system, replace the propeller with the specified test propeller, and install the motor in a test tank.
Test propeller: /90890-01625
- Check for normal operation of the engine stop system.

FUEL LEAKAGE
Check for fuel leakage..
WATER LEAKAGE
Check for water leakage..
EXHAUST LEAKAGE
Check for exhaust leakage..
ENGINE AND LOWER UNIT NOISE
Check the engine and lower unit for abnormaL noise..
IDLE-SPEED
Check that the engine speed at fully-closed
throttle is correct.
IGNITION TIMING
Check that the ignition timing at fullyclosed and fully-open throttle positions is
correct..
MOTOR EXTERIOR
Check the motor exterior for any flaking of
the paint, and if necessary touch-up with
paint of the original color..
INSTRUCTING THE NEW OWNER
Instruct the new owner on the operation of
all controls and the break-in procedure.
Also advise him on propeller-to-boat matching.


