¡PREPÁRATE PARA EL INVIERNO: Descuentos del 10 al 50 % en todas las piezas OEM!

A menos que lo prohíba el fabricante. No incluye productos de recambio ni productos de la marca Crowley Marine. Precio indicado.

Nuestros almacenes están cerrados el jueves 26 y el viernes 27 de noviembre. ¡Feliz Día de Thanksgiving de los Estados Unidos!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

Owner's Manual DF9.9, DF15 Motor Removal And Transporting

Productos relacionados:
Owner's Manual DF9.9, DF15 Motor Removal And Transporting
99011-94J03-03B
Suzuki Marine

MOTOR REMOVAL

TILLER HANDLE MODEL

  1. Make sure that the engine has stopped completely.

  2. Remove the fuel hose from the motor. 3. Remove the motor cover.

  3. Remove the snap pin (1), the washer (2), the pin (3) and the fastener (4). Remove the screw (5).

  4. Remove the side cover rubber (6).

  1. Remove the three side cover bolts (7).

  1. Remove the screw 8 and the starboard engine side cover.

  1. Loosen the carburetor drain screw A and drain the gasoline into a suitable container. After draining, retighten the drain screw.

Use a proper, safe container to store any gasoline drained from the outboard motor.

  1. Install the engine side cover and motor cover.

  2. Remove the mounting bolts. 11. Loosen the clamp screws.

  3. Lift the motor off the transom.

  4. Stand the motor vertically and drain the water from the lower unit.

  5. To carry, hold the motor by gripping the steering bracket and engine side cover.

REMOTE CONTROL MODEL

If it is necessary to remove the outboard motor from your boat, we recommend that you ask your authorized Suzuki Marine Dealer to do the work for you.

MOTOR TRANSPORTING

When transporting the motor, place the motor either vertically or horizontally.

Vertical transport:

Attach the clamp bracket to a stand by securing two transom bolts.

Horizontal transport:

Raise the tiller handle (if equipped) and rest the motor on a case protector with the port side downwards as shown.

• Do not rest the engine in any of the positions shown below, as oil may enter the cylinder from the sump or outer casings may be damaged.

• Do not place the engine on its side before the cooling water has drained from it completely, as water may enter the cylinder through the exhaust port and cause problems.

Do not let the lower unit of the outboard sit higher than the power head during transporting or storing, or water may trickle into the power head, causing damage to the engine.

TRAILERING

When trailering your boat with the motor attached, keep the motor in the normal operating position unless there is not enough ground clearance. If you need more ground clearance, trailer the motor in a tilted position using a transom saver bar or similar device to support the weight of the motor.

When trailering the boat and the motor, do not use the tilt up lock arm to hold the motor in the fully tilted position. Towing motion or poor road surfaces may cause unexpected tilt lock release, resulting in damage to the motor and the tilt lock mechanism.

Share on social:

Productos relacionados