¡PREPÁRATE PARA EL INVIERNO: Descuentos del 10 al 50 % en todas las piezas OEM!

A menos que lo prohíba el fabricante. No incluye productos de recambio ni productos de la marca Crowley Marine. Precio indicado.

Nuestros almacenes están cerrados el jueves 26 y el viernes 27 de noviembre. ¡Feliz Día de Thanksgiving de los Estados Unidos!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

Owner's Manual DF70, DF60 Submerged Motor

Productos relacionados:
Owner's Manual DF70, DF60 Submerged Motor
99011-99E10-03A
Suzuki Marine

SUBMERGED MOTOR

If your motor has been accidentally submerged in water, it must receive a special repair service as soon as possible to prevent corrosion. If possible, have a qualified marine dealer service the engine. If immediate servicing is not available, take the following steps to help protect your motor. In the event that your motor is accidentally submerged, take the following steps:

  1. Get the motor out of the water as soon as possible.

  2. Remove the engine cover and immediately wash the engine thoroughly with fresh water to completely remove all salt, mud, and sea weed.

  3. Remove the spark plugs. Drain the water from the cylinders through the spark plug holes by manually turning the flywheel several times.

  4. Check if any water is evident in the engine oil. If water is seen, remove the oil drain plug and drain the oil. After draining, tighten the oil drain plug.

  5. Drain the fuel line and all filters.

Keep flames and sparks away from gasoline. Dispose of unwanted fuel properly

  1. Pour one tablespoon of engine oil in through each spark plug hole. Coat the engine inner parts with oil by turning the engine over with the emergency starter rope. Don’t use the electric starter, as this may bend the connecting rods.

If you encounter friction or resistance while cranking the engine, stop at once and do not attempt to start the engine until it is inspected or repaired.

  1. Have your authorized Suzuki marine dealer inspect the engine as soon as possible.

If the boat’s fuel tank filler and vent were also submerged, the fuel supply could be contaminated and should be inspected.

STORAGE PROCEDURE

MOTOR STORAGE

When storing your motor for a long period of time (for example, at the end of the boating sea son), it is recommended that you take your motor to your authorized Suzuki Marine Dealer. However, if you choose to prepare the motor for storage yourself, follow the procedure outlined below:

  1. Change the gear oil as outlined in the GEAR OIL section.

  2. Change the engine oil as outlined in the ENGINE OIL section.

  3. Fill a high quality fuel stabilizer to the fuel tank according to the instructions on the stabilizer can.

  4. Flush the water passages in the motor thoroughly. Refer to the FLUSHING THE WATER PASSAGES (Engine running) section.

  5. Readjust the water flow, run the engine at about 1500 r/min in neutral for five minutes to distribute the stabilized fuel through the engine.

  6. Spray Suzuki fogging oil into the air inlet hole as illustrated until the engine starts to smoke.

Share on social:

Productos relacionados