Disassembly
Disconnect the joint links from the magneto control lever and carburetor control lever.
Loosen the adjust bolt lock nuts of the two throttle wires, and remove the nuts on the carburetor control lever side.
Remove the "cable end" from the carburetor control lever, and remove the throttle wires from the throttle wire stay.

1.Throttle wires
- Adjust bolts
- Locknuts
- Carburetor control lever
3.Remove the bolt and carburetor control lever.

Bolt
Collar
Nynol bushing
Remove the bolt and magneto control lever.

- Bolt
- Collar
Be careful so that the nylon bushing and collars are not lost.
- Remove the throttle wire stay from the cylinder body.
Inspection
- Check the nylon bushing for cracks and wears. Replace it if damaged.

- Check the link end for cracks and settling. Replace it if damaged.

