PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Os nossos armazéns encerram na quinta-feira, 26, e na sexta-feira, 27 de novembro. Feliz Dia da Thanksgiving dos Estados Unidos!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

Lower Unit [Lower Unit] [2008]

Productos relacionados:

Applicable Models

Model group Year Model Serial
Yamaha International 2001 - 2005 4hp All
Yamaha Outboard 1999 - 2005 4hp All

Lower Unit [Lower Unit] [2008]
LIT-18616-01-79
Yamaha Marine

EXPLODED DIAGRAM

REMOVAL AND INSTALLATION CHART

Step Procedure/Part name Q'ty Service points
LOWER UNIT REMOVAL Follow the left "Step" for removal.
1 Cotter pin 1 Not reusable
2 Propeller nut 1
3 Washer 1
4 Propeller 1
5 Spacer 1
6 Bolt (anode) 1
7 Toothed washer (anode) 1
8 Anode 1
9 Grommet 1
10 Bolt (shift rod connector) 1 NOTE:
Set the shift lever to reverse position, and loosen the bolt (shift rod connector).

Step Procedure/Part name Q'ty Service points
11 Bolt with washer (lower unit) 2 For S-transom model
*For L-transom model
NOTE:
When removing, screw out the bolt (rear) from upper case and remove the lower unit with extension.
12 Lower unit ass'y 1
13 Lower unit with extension 1 For L-transom model
14 Dowel pins 2
15 Dowel pins 2 For L-transom mode
16 Circlip 1
17 Bushing 1
Reverse the removal steps for installation.

SERVICE POINTS

Lower unit removal

NOTE:

  • It is possible to remove the Lower unit from the upper case without removing the power unit.
  • Set the shift lever (1) to "REVERSE" position, then remove and install the lower unit.
  1. Remove:
  • Grommet (2)
  1. Loosen:
  • Bolt (3) (shift rod connector)

  1. Remove:
  • Bolt (1) (lower unit)

  • Lower unit (2)

NOTE:
For long transom model:

  • When removing, screw out the bolt (rear) from upper case and remove the lower unit with extension.
  • When installing, hold the bolt (rear) in hole of the extension and install the lower unit with extension to the upper case.

Lower unit installation

  1. Tighten:
  • Bolt (1) (shift rod connector)

NOTE:
Push down the tilt lock plate (2) until it contacts the stopper and locate the shift lever in "REVERSE" position. Then tighten the bolt (1).

Share on social:

Productos relacionados