Fuel control system

(1) ECM
(2) Oil pressure sensor
(3) Intake air temperature sensor
(4) Engine temperature sensor
(5) Main relay
(6) Fuse (5 A)
(7) Fuse(30 A)
(8) Fuse(20 A)
(9) Battery
(10) Pulser coil
(11) Stator coil
(12) Rectifier Regulator
(13) Intake air pressure sensor
(14) Thermoswitch
(15) Throttle position sensor
(16) Shift cut switch
(17) Neutral switch
(18) Idle speed control
(19) High-pressure fuel pump
(20) Low-pressure fuel pump
(21) Fuel pump driver and isolator
(22) Fuel injector

B : Black
Br : Brown
G : Green
L : Blue
O : Orange
P : Pink
R : Red
Y : Yellow
B/W : Black/white
B/Y : Black/yellow
G/B : Green/black
G/R : Green/red
G/W : Green/white
G/Y : Green/yellow
L/R : Blue/red
L/Y : Blue/yellow
O/B : Orange/black
O/R : Orange/red
O/Y : Orange/yellow
P/G : Pink/green
P/W : Pink/white
R/Y : Red/yellow
W/B : White/black
W/G : White/green
W/R : White/red
Y/G : Yellow/green
Checking the low-pressure fuel pump and high-pressure fuel pump
- Disconnect the starter relay lead (brown lead) (1) to prevent the engine from starting.

Turn the engine start switch to ON.
Listen for the operating sound of the high-pressure fuel pump (2). Replace if there is no sound.

• After the engine start switch is turned to ON, the high-pressure fuel pump will operate for 5 seconds.
• Check the operation of the low-pressure fuel pump (3) using the “Stationary test” of the Yamaha Diagnostic System.
