EXPLODED DIAGRAM

REMOVAL AND INSTALLATION CHART
| Step | Procedure/Part name | Q'ty | Service points |
|---|---|---|---|
| TRIM CYLINDER DISASSEMBLY | Follow the left "Step" for removal. | ||
| Tilt cylinder assembly | Refer to "TILT CYLINDER" section. | ||
| 1 | Trim cylinder end screw | 2 | |
| 2 | Dust seal | 2 | |
| 3 | O-ring | 2 | |
| 4 | Trim rod | 2 | |
| 5 | O-ring | 2 | |
| 6 | O-ring | 2 | |
| 7 | Backup ring | 2 | |
| Reverse the removal steps for installation. |
SERVICE POINTS
Trim rod removal and installation
- Loosen and tighten:
- Trim rod
Trim cylinder wrench: YB-06175-2B/90890-06542

Trim rod inspection
- Inspect:
- Trim rod
Bend/Excessive corrode -> Replace.
Rust lightly -> Polish (with #400-600 abrasive paper).
- Inspect:
- Trim piston
Excessive scratch -> Replace.
