¡PREPÁRATE PARA EL INVIERNO: Descuentos del 10 al 50 % en todas las piezas OEM!

A menos que lo prohíba el fabricante. No incluye productos de recambio ni productos de la marca Crowley Marine. Precio indicado.

Nuestros almacenes están cerrados el jueves 26 y el viernes 27 de noviembre. ¡Feliz Día de Thanksgiving de los Estados Unidos!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

Bracket Unit [Swivel Bracket And Steering Arm] [2004]

Productos relacionados:

Applicable Models

Model group Year Model Serial
Yamaha International 2004 60hp All
Yamaha Outboard 2004 60hp All

Bracket Unit [Swivel Bracket And Steering Arm] [2004]
LIT-18616-FT-60
Yamaha Marine

Swivel bracket and steering arm

No. Part name Q’ty Remarks Tightening torques Tightening torques Tightening torques Tightening torques
Stage N-m kgf-m ft-lb
1 Steering arm 1
2 Washer 1
3 Bushing 1
4 O-ring 2 Not reusable
5 Bushing 2
6 Swivel bracket 1
7 Bushing 1
8 Port tilt stop lever 1
9 Circlip 1
10 Steering yoke 1
11 Bushing 1
12 Bushing 1
13 Tilt stop lever joint 1
14 Spring holder 1
15 Bolt 1 M6 x 10 mm
16 Spring 1
17 Bushing 1
18 Pin 2
19 Bushing 1
20 Starboard tilt stop lever 1

Removing the steering arm

  1. Remove the circlip (1).

  2. Remove the steering yoke (2) by striking it with a plastic hammer.


S62Y7380

  1. Remove the steering arm from the swivel bracket by pulling the arm off the bracket.

Installing the steering arm

  1. Install the washer (1), bushing (2) O-ring (3) and bushing (4)onto the steering arm (5).

  2. Place the swivel bracket (6)in an upright position, and then install the steering arm onto the swivel bracket.


S62Y7390

  1. Install the bushing(7), O-ring (8), and bushing (9) onto the swivel bracket.


S62Y7400

  1. Install the steering arm( 5) into the steering yoke(10) by aligning the center (a) of the yoke with the center(b)of the steering arm.

5.Install the circlip (11).


S62Y7410

  1. Inject grease into the grease nipple until grease comes out from both the upper and lower bushings (c).


S62Y7420

Share on social:

Productos relacionados