¡PREPÁRATE PARA EL INVIERNO: Descuentos del 10 al 50 % en todas las piezas OEM!

A menos que lo prohíba el fabricante. No incluye productos de recambio ni productos de la marca Crowley Marine. Precio indicado.

Nuestros almacenes están cerrados el jueves 26 y el viernes 27 de noviembre. ¡Feliz Día de Thanksgiving de los Estados Unidos!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

Bracket Unit [Ptt Motor] [1996]

Productos relacionados:

Applicable Models

Model group Year Model Serial
Yamaha Outboard 1996 150hp All
Yamaha Outboard 1996 175hp All
Yamaha Outboard 1996 200hp All
Yamaha Outboard 1996 225hp All
Yamaha Outboard 1996 250hp All

Bracket Unit [Ptt Motor] [1996]
LIT-18616-01-41
Yamaha Marine

EXPLODED DIAGRAM

REMOVAL AND INSTALLATION CHART

Step Procedure/Part name Q'ty Service points
PTT MOTOR DISASSEMBLY Follow the left "Step" for removal.
Refer to "RESERVOIR TANK AND MOTOR REMOVAL" section.
1 Through bolt 2
2 Commutator end cap 1
3 Brush holder assembly 2
4 Stator 1
5 Armature 1
6 Commutator end cap 1
7 Oil seal 1
8 Bearing 2
Reverse the removal steps for installation.

SERVICE POINTS

Motor inspection

  1. Inspect:
    • Commutator
    Dirty -> Clean with #600 abrasive paper.

  2. Inspect:
    • Segment undercut Clog -> Clean.

Remove all particles of metal with com pressed air.

  1. Measure:
    • Commutator diameter (a)
    Out of specification -> Replace.

Commutator diameter limit:
6G510: 27 mm (1.06 in)
6E503: 21 mm (0.83 in)

  1. Inspect:
    • Armature coil continuity
    Out of specification -> Replace.
Armature coil continuity: Armature coil continuity:
Commutator segments Continuity
Segment - laminations Discontinuity
Segment - shaft Discontinuity
  1. Measure:
    • Brush length (a)
    Out of specification -> Replace.

Brush length limit:
6G510: 7.5 mm (0.30 in)
6E503: 4.8 mm (0.19 in)

  1. Inspect:
    • End cap
    Crack/Damage-> Replace.

  2. Inspect:
    • Oil seal
    Wear/Damage -> Replace.

Motor assembly

  1. Check:
    • Motor operation
    Out of specification -> Repair.
Motor operation: Motor operation:
Blue (+), Green (-) Clockwise
Green (+), Blue H Counterclockwise
Share on social:

Productos relacionados