¡PREPÁRATE PARA EL INVIERNO: Descuentos del 10 al 50 % en todas las piezas OEM!

A menos que lo prohíba el fabricante. No incluye productos de recambio ni productos de la marca Crowley Marine. Precio indicado.

Nuestros almacenes están cerrados el jueves 26 y el viernes 27 de noviembre. ¡Feliz Día de Thanksgiving de los Estados Unidos!

Busca en más de 1 millón de partes originales
Fácil de usar  diagramas de piezas Mejor precio  garantizado Soporte experto  en vivo 50+ años  al servicio de los navegantes Gran selección de piezas OEM  -  de 1950 a 2026 La mayoría de las piezas en stock  -  Cumplimiento el mismo día
Piezas están disponibles- Ejecuta el mismo día

Bracket Unit [Power Trim And Tilt Unit] [2004]

Productos relacionados:

Applicable Models

Model group Year Model Serial
Yamaha International 2004 60hp All
Yamaha Outboard 2004 60hp All

Bracket Unit [Power Trim And Tilt Unit] [2004]
LIT-18616-FT-60
Yamaha Marine

Power trim and tilt unit

No. Part name Q’ty Remarks Tightening torques
Stage N-m kgf-m ft-lb
1 Power trim and tilt 1 EHT/ET models
2 Hydro tilt 1 EHD/ED models
3 Plastic tie 3 Not reusable
4 PTT motor lead 2
5 Washer 2
6 Bolt 2 M8 x 16 mm
7 Circlip 1 EHT/ET models
8 Shaft 1 EHT/ET models
9 Bushing 2 EHT/ET models
10 Collar 1 EHT/ET models
11 Tilt pin 1
12 Collar 1
13 Collar 1
14 Shaft 1
15 Bushing 2 EHD/ED models
16 Circlip 2 EHD/ED models
17 Shaft 1 EHD/ED models
18 Collar 1 EHD/ED models

Removing the power trim and tilt/hydro tilt

  1. Fully tilt the outboard up, and then support it with the tilt stop lever (1).

S62Y7440

WARNING
After tilting up the outboard, be sure to support it with the tilt stop lever.

Otherwise, the outboard could suddenly lower if the power trim and tilt unit should lose fluid pressure.

  1. Loosen the plastic locking tie (2), and then pull out the PTT motor lead (3).

  2. Remove the tilt pin (4).

  3. Remove the circlip(s) (5) and the shaft (6).

  4. Loosen the bolt (7), and then remove the shaft (8).

  5. Remove the power trim and tilt/hydro tilt (9).

NOTE:
To remove the power trim and tilt/hydro tilt, lower the tilt rod slightly.

Share on social:

Productos relacionados