PREPARE FOR WINTER: 10-50% discount on all OEM parts!

Unless prohibited by manufacturer. Does not include aftermarket or Crowley Marine branded products. Priced as marked.

Our warehouses are closed on Thursday and Friday, November 26th and 27th. Happy Thanksgiving!

Search Over 1 Million OEM Parts
Easy-to-use  parts diagrams Best price  guarantee Expert  live support 50+ years  of serving boaters Huge selection of OEM parts  -  from 1950 to 2026 Most parts in stock  -  Same day fulfillment
Most parts in stock- Same day fulfillment

Service Manual G2 74° V6 Service Manual 5010014 Gearcase [Shift Actuator]

Related Products:
Service Manual G2 74° V6 Service Manual 5010014 Gearcase [Shift Actuator]
5010014
BRP Marine

Shift Actuator

Control Circuit Tests

Use appropriate test leads or adapters such as Test Probe Kit, P/N 342677, when performing electrical tests.
NEVER pierce the insulation of the engine wiring, or use any piercing-style test probe. Piercing insulation damages the wire and can cause other unintended electrical problems.

Circuit tests check the integrity of the main engine harness and EMM circuits using resistance or diode tests. Continuity tests check the integrity of ground circuits and/or the 55V circuit. These tests eliminate the need to disconnect the engine harness from the EMM, or remove the EMM.

Remove the electrical connector from the shift actuator.

Make sure the key switch is OFF.

Use the diode test function of a digital multimeter to check the shift actuator circuits. Use an appropriate test probe lead to connect the negative meter lead to the wire listed in the table, connect the positive meter lead to an engine ground.

  1. Engine harness connector (shift actuator)
Shift Actuator Circuit Diode Test
Wire Pin Result
Yellow/Blue 1 approximately 0.5 VDC
Yellow/Green 2 approximately 0.5 VDC
Red/White 3 0.11 to 0.125 VDC
Yellow/Black 4 2.1± 0.5 VDC

Results:

  • No reading (OL or ∞) indicates an open circuit.
  • A reading of zero (0) indicates an short circuit. Isolate the faulty component. Check wiring and connections. Repair or replace faulty wiring.

Shift Actuator Ground Circuit

Use a digital multimeter with appropriate test probe leads to measure the ground circuit resistance. Connect the positive meter lead to the engine harness connector wire listed in the table. Connect the negative meter lead to engine ground.

Shift Actuator Ground Circuit Resistance
Wire Pin Result
Black/White 5 < 1 Ω

Results:

An infinite reading (∞) indicates an open circuit. Isolate the faulty component. Check wiring and connections. Repair or replace faulty wiring.

Neutral Circuit

There are no tests for the neutral circuit.

Share on social:

Related Products