TACHOMETER DISPLAY INDICATION
CAUTION SYSTEM

When a problem is detected, the caution name appears on the display screen of tachometer-monitor, caution buzzer sounds and caution lamps lights continuously.
| CAUTION TYPE | TACHOMETER DISPLAY INDICATION |
|---|---|
| Over-revolution | Rev Limit [ NOTE 1] |
| Over Revolution [NOTE 2 ] | |
| Low oil pressure | Low Oil Pressure |
| Over heat | Over Heat |
| Low battery voltage | Low Batt Voltage |
When the engine speed detected by ECM exceeds the preset maximum engine speed.
Engine is continuously operated with the over-revolution limiter that exceeds the preset maximum engine speed for more than 10 seconds.
SELF-DIAGNOSTIC SYSTEM

When an abnormality occurs in a signal from sensor, switch, etc., the diagnostic code appears on the display screen of tachometer-monitor, caution buzzer sounds and caution lamps lights continuously. When engine is not running, the buzzer sounds according to self-diagnostic code pattern.
• When two or more failures have occurred at the same time, the caution buzzer beeps three times repeatedly in the order of descending priorities according to the diagnostic code pattern (while the engine is standstill with the ignition switch in ON).
• In the display screen, the following diagnostic code information appears when “ENTER” button is pressed. This information is shown in the order of occurrence.
OIL CHANGE REMINDER SYSTEM

When the total motor operating hours have reached the pre programmed hours, the “Change Oil” appears on the display screen of tachometer-monitor, caution buzzer sounds if engine is not running (but ignition switch ON) and caution lamps lights continuously.
