PREPARE FOR WINTER: 10-50% discount on all OEM parts!

Unless prohibited by manufacturer. Does not include aftermarket or Crowley Marine branded products. Priced as marked.

Our warehouses are closed on Thursday and Friday, November 26th and 27th. Happy Thanksgiving!

Search Over 1 Million OEM Parts
Easy-to-use  parts diagrams Best price  guarantee Expert  live support 50+ years  of serving boaters Huge selection of OEM parts  -  from 1950 to 2026 Most parts in stock  -  Same day fulfillment
Most parts in stock- Same day fulfillment

Service Manual DF40, DF50 Reassembly [162][Df40, Df50]

Related Products:
Service Manual DF40, DF50 Reassembly [162][Df40, Df50]
99500-87J08-01E
Suzuki Marine

REASSEMBLY

Reassembly is reverse order of removal with special attention to the following steps.

CLAMP BRACKET

Insert PORT and STBD bushings (2) into the swivel bracket (1). Install clamp bracket (3), (4) and clamp bracket shaft 5 to swivel bracket (1).

Install clamp bracket shaft nut (6). Leave nut loose for easier installation of PTT unit.

Before installing clamp bracket to swivel bracket, apply grease to clamp bracket shaft and bushings.

Install PTT unit assembly, lower shaft and bushings in position between clamp brackets.

(See “INSTALLATION” in POWER TRIM & TILT section for PTT unit installation.)

Tighten clamp bracket shaft nut (6) to specified torque.

STEERING BRACKET

Apply Water Resistant Grease to steering bracket shaft.

Apply grease to bushings, oil seal lip and pilot shaft portion of steering bracket.

Install upper bushing (1), steering adjuster (2) and washer (3) to swivel bracket.

Be certain that steering adjuster (2) is placed between upper bushing (1) and swivel bracket casing.

Install lower bushing (4) and swivel bracket seal (5) to swivel bracket.

Install seal (5) with lip (spring side) facing downward.

Install steering bracket (6) to swivel bracket.

LOWER MOUNT BRACKET

Install washer (7) and shim (8), and then slide the lower mount bracket (9) upward on the splines until it contacts the shim. Install circlip (10) to retain bracket.

BONDING WIRE

Reattach bonding wire to clamp bracket and swivel bracket, then ntighten screw securely.

The insulation washer must be installed between the bonding wire terminal and bracket.

LUBRICATION

The insulation washer must be installed between the bonding wire terminal and bracket.

Share on social:

Related Products