SWIVEL BRACKET BUSH
The swivel bracket bush has been changed in shape.

TILLER HANDLE ASSY
The wire connector of the tiller handle assy has been changed to 16-pin connector.

PTT MOTOR RELAY
The PTT relays (for UP and for DOWN) have been incorporated and changed in shape.

In accordance with the change of PTT relay, the lead connector of PTT motor and lead grommet have been changed.

PTT MOTOR RELAY

INSPECTION
Disconnect battery cable from battery.
Disconnect all cables/lead wires from PTT relay.
Check resistance between each two (2) lead wires.

Between “P” wire and “B” wire: 25 – 37 Ω
Between “Lbl” wire and “B” wire: 25 – 37 Ω
- Connect “R” wire to positive (+) terminal, and black wire to negative (-) terminal of 12 V battery.
Each operation test must be performed within 3 – 5 seconds to avoid overheat damage to the relay coil.

- Temporarily connect a jumper wire from the “P” lead wire to the battery positive + terminal, then check voltage between “G” wire and “B” wire.

Between “G” wire and “B” wire: 12 V (Battery voltage)
- Temporarily connect a jumper wire from the “Lbl” lead wire to the battery positive + terminal, then check voltage between “Bl” wire and “B” wire.
Between “Bl” wire and “B” wire: 12 V (Battery voltage)
- If inspection in step 3 and/or step 5, 6 fails, replace PTT relay.
