PREPARE FOR WINTER: 10-50% discount on all OEM parts!

Unless prohibited by manufacturer. Does not include aftermarket or Crowley Marine branded products. Priced as marked.

Our warehouses are closed on Thursday and Friday, November 26th and 27th. Happy Thanksgiving!

Search Over 1 Million OEM Parts
Easy-to-use  parts diagrams Best price  guarantee Expert  live support 50+ years  of serving boaters Huge selection of OEM parts  -  from 1950 to 2026 Most parts in stock  -  Same day fulfillment
Most parts in stock- Same day fulfillment

Service Manual DF40, DF50 Oil Pressure [39][Df40, Df50]

Related Products:
Service Manual DF40, DF50 Oil Pressure [39][Df40, Df50]
99500-87J08-01E
Suzuki Marine

OIL PRESSURE

Oil pressure ( at normal operating temp. ): 300 - 380 kPa (3.0 - 3.8 kg/cm2, 43 - 54 psi.) at 4000 r / min.

The figure shown above is a guideline only, not an absolute service limit.
If oil pressure is lower or higher than specification, the following causes may be considered.
(See page 6-66 for oil passage locations)

Low oil pressure
• Clogged oil filter
• Leakage from oil passages
• Defective oil pump
• Defective oil pressure regulator
• Damage O-ring
• Combination of above items.

High oil pressure
• Using an engine oil of too high viscosity
• Clogged oil passage
• Clogged oil pressure regulator
• Combination of above items

TEST PROCEDURE

(1) Check the engine oil level.
(2) Remove the PORT side lower cover.
(3) Remove the plug (1) for oil pressure service port.

(4) Install the oil pressure gauge in place of service port.

09915-77310 : Oil pressure gauge
09915-78211 : Oil pressure gauge adapter

(5) Remove bolt and No.1 ignition coil.
(6) Connect special tool (H . T cord with plug cap adapter) between No.1 ignition coil and spark plug.

09930-88720 : H . T cord with plug cap adapter

(7) Attach engine tachometer to the special tool.

09900-26006 : Engine tachometer

(8) Start the engine and warm up engine as follow :

Summer : 5 min. at 2000 r / min.
Winter : 10 min. at 2000 r / min.

(9) After warming up, shift into forward gear and increase the engine speed to 4000 r / min. then compare the pressure indicated on the gauge to specifications.

(10) After testing, reinstall parts removed earlier. (plug, side lower cover, etc.)

Share on social:

Related Products