Step 1: INSTALLATION

- Use care when installing to prevent any O-ring damage.
- Always replace injector cushion with new.
Assemble cushion to fuel injector.
- Apply thin coat of fuel to injector O-rings before installing injector into intake manifold.
- Install injector stopper and tighten stopper screw securely.
- Connect lead wire connector to injector securely.
- Turn ignition switch “ON” for 3 seconds (to operate fuel pump), then turn it “OFF”.
Repeat this (ON and OFF) procedure 3 or 4 times to pressurize the fuel system.
Check for fuel leaks around fuel injector.
