PREPARE FOR WINTER: 10-50% discount on all OEM parts!

Unless prohibited by manufacturer. Does not include aftermarket or Crowley Marine branded products. Priced as marked.

Our warehouses are closed on Thursday and Friday, November 26th and 27th. Happy Thanksgiving!

Search Over 1 Million OEM Parts
Easy-to-use  parts diagrams Best price  guarantee Expert  live support 50+ years  of serving boaters Huge selection of OEM parts  -  from 1950 to 2026 Most parts in stock  -  Same day fulfillment
Most parts in stock- Same day fulfillment

Service Manual DF40, DF50 Inspection For Resistance [75][Df40, Df50]

Related Products:
Service Manual DF40, DF50 Inspection For Resistance [75][Df40, Df50]
99500-87J08-01E
Suzuki Marine

INSPECTION FOR RESISTANCE

09930-99320 : Digital tester
Tester range : Ω (Resistance)

Make sure ignition switch is always OFF when measuring resistance.

(1) Disconnect battery cables from battery.
(2) Disconnect all wires from ECM.
(3) Connect the tester probes to terminal of wire harness side, and measure resistance according to the “RESISTANCE TABLE".

RESISTANCE TABLE

1: Disconnect remote control wire harness, and connect tester probe to terminal (A) (Gray wire).

OTHER INSPECTION

FUEL INJECTOR OPERATING SOUND (CRANKING)
(1) Touch a sound scope or long blade screw driver to fuel injector body as shown.
(2) Crank engine and check for injector operating sound.

Injector operating sound : “Click”

FUEL INJECTOR OPERATING SOUND (INDIVIDUAL)
(1) Disconnect fuel injector wire, and connect the test cord.

09930-89260 : Injector test cord A

(2) Connect Gray wire to body ground.
(3) Momentarily touch Black/Yellow wire to starter motor relay right terminal (connected to battery positive (+) terminal), and check for injector operating sound.

Injector operating sound : “Click”

Connecting fuel injector to battery positive for more than a few seconds may cause injector overheating and possible injector solenoid failure.

FUEL INJECTOR OPERATING SIGNAL

09930-89930 : 8-pin test cord

Peak voltmeter Stevens CD-77
Tester range : NEG5O

(1) Connect the test cord as shown, then turn ignition switch ON.
(2) Connect the tester probe (-) (Black) to starter motor relay right terminal (connected to battery positive (+) terminal) as shown.

Share on social:

Related Products