Service Manual

Remove bolt (15) and water tube (16).


Remove bolts (17), water pressure valve cover (18), pressure valve (19) and valve case (20).
INSPECTION
If any component is found to be excessively worn, cracked, defective or damaged in any way, it must be replaced.

Mid unit component
Check oil pan, driveshaft housing, engine holder and mount covers.
If cracks, defects or other damage is found, replace it.

Mount
Check upper and lower mount.
If excessive wear, corrosion, or other damage is found, replace mount.

Water tube
Check water tube.
If a clog or obstruction is found, clean water tube.
If cracks, corrosion or other damage is found, replace water tube.
Check water tube grommet.
If excessive wear or other damage is found, replace grommet.

Oil seal
Check driveshaft upper oil seal for leakage or damage.
If cracks, cuts or other damage is found, replace seal.
Install oil seal with lip (spring side) facing downward.

Water pressure valve
If salt deposits, corrosion, wear, or other damage is found, clean or replace.
