Service Manual

Remove screw and pump bracket (10).

Remove high pressure fuel pump (11) from separator cover and then disconnect pump lead wire connector.
INSPECTION
If cracks, excessive wear or other damage is found on any component, replace component.

Needle valve / Valve seat
Check needle valve and valve seat.
If grooved or damaged, replace valve and seat.
If dirt is found, clean.

Float
Check float.
If cracked or damaged, replace float.

Filter
Check pump suction filter.
If clogged or damaged, clean or replace filter.
Fuel pressure regulator
Check fuel pressure regulator operation.

09952-99310 : Hand air pump (1)
09940-44120 : Air pressure gauge (2)
09940-44130 : Attachment (3)
09912-58490 : Hose (4)
- Connect special tools to inlet side of regulator as shown.
- Pump air into regulator using pump (1) until air is released through outlet side.
- Note pressure on gauge when air is released.
Regulator operating pressure : 240 – 270 kPa (2.4 – 2.7 kg/cm2, 34.1 – 38.4 psi.)
If measurement exceeds specification, replace regulator.
